Frigidaire ES200/300 manual Before Setting Oven Controls, Oven Vent Location, Arranging Oven Racks

Page 6

Before Setting Oven Controls

Oven Vent Location

For models equipped with ceramic cooktops, the oven vent is located under the left rear side of the control panel. When the oven is on, warm air is released through the vent. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT BLOCK OVEN VENT.

Arranging Oven Racks

ALWAYS ARRANGE OVEN RACKS WHEN THE OVEN IS COOL (PRIOR TO

OPERATING THE OVEN). Always use oven mitts when using the oven.

Removing & Replacing Oven Racks

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

Using proper cookware

Cookware should have flat bottoms that make good contact with the entire surface heating element. Check for flatness by rotating a ruler across the bottom of the cookware (See Fig.1). Be sure to follow the recommendations for using cookware as shown in Fig. 2.

Figure 1

Note: The size and type of cookware used will influence the setting needed for best cooking results.

Deep fat frying - Use a thermometer and adjust the surface control knob accordingly. If the fat is too cool, the food will absorb the fat and be greasy. If the fat is too hot, the food will brown so quickly that the center will be undercooked. Do not attempt to deep fat fry too much food at once as the food will neither brown nor cook properly.

Figure 2

6

Image 6 Contents
316257123 REV. a Welcome & Congratulations Register Your ProductImportant Safety Instructions Important Instructions for Usingyour Cooktop Features At a Glance Oven Vent Location Before Setting Oven ControlsUsing proper cookware Arranging Oven RacksAbout the Radiant Surface Elements Element On and Hot Surface Indicator LightsAbout the Ceramic Glass Cooktop Dual Radiant Surface Elements some modelsSetting Surface Controls To Operate Single Radiant Surface ElementsSetting the Warming Zone Control some models Setting the Warming Zone ControlTo Operate Dual Radiant Surface Elements If equipped Temperature conversion Oven Control FunctionsTo Change the Minute Timer while it is in use Setting Oven ControlsTo Set the Minute Timer To Set the ClockTo Set or Change the Temperature for Baking To Set Control for Continuous Bake or 12 Hour Energy SavingTo Set Control for Oven Lockout Benefits of Speed Bake Cooking System General Cooking InstructionsTo Set Speed Bake Cooking System Decrease CookTo Set the Timed Bake Feature some models When the Set Bake Time Runs OutTo Broil Rack Position From Top FoodSelf-Cleaning Self-Cleaning OvenAdhere to the following cleaning precautions To Set the Controls for a Self-Clean Cycle To Start the Self-Clean CycleStopping or Interrupting a Self-Cleaning Cycle When the Self-Clean Cycle is CompletedCare & Cleaning Surfaces How to CleanPlastic or foods with a high sugar content Cooktop Cleaning and MaintenanceCleaning Recommendations for Ceramic Glass Cooktop For light to moderate soilDo not use the following on the ceramic glass cooktop Cleaning Recommendations for Ceramic Glass CooktopsRemoving and Replacing the Oven Door all models To Remove Oven DoorTo Adjust Oven Temperature Adjusting Your Oven TemperatureCare and Cleaning of Stainless Steel some models Changing the Oven Light some modelsSolutions to Common Problems Before You CallAdjusting Oven Temperature in this Use & Care Manual Range Warranty