Frigidaire Official Manual for Replacing Oven Light and Maintenance for Range Models

Replacing oven light

CAUTION

Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass.

The light bulb is located at the rear of the oven cavity and is covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use.

CARE & CLEANING

Special door care instructions - Most oven doors contain glass that can break. Read the following recommendations:

•Do not close the oven door until all the oven racks are fully in place.

•Do not hit the glass with pots, pans, or any other object.

•Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later time.

To replace the oven light bulb:

1.Turn electrical power off at the main source or unplug the range.

2.Press wire holder to one side to release the glass shield that covers the light bulb.

3.Replace bulb with a new 40 watt appliance bulb.

4.Replace glass shield over bulb and snap wire holder back into place.

5.Turn power back on again at the main source (or plug the appliance back in).

6.The clock will then need to be reset. To reset, see “Setting the clock” in this Use & Care Guide.

Removing and replacing the lift-off oven door

CAUTION

The oven door is heavy. For safe, temporary storage, lay the oven door flat with the inside of the door facing down.

To remove oven door:

1.Open oven door completely (horizontal with floor - Fig.1).

2.Pull the door hinge locks on both left and right door hinges down from the oven frame completely towards the oven door (Fig. 2). A tool such as a small flat-blade screwdriver may be required.

3.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - Fig. 3).

4.Close the door to the broil stop position (the oven door will stop into this position just before fully closing).

5.With the oven door in the broil stop position, lift the oven door hinge arms over the roller pins located on each side of the oven frame (Fig. 4).

To replace oven door:

1.Firmly grasp both sides of oven door along the door sides (Do not use the oven door handle - Fig. 3).

2.Holding the oven door at the same angle as the removal position, seat the hook of the hinge arm over the roller pins located on each side of the oven door frame (Fig. 4). The hook of the hinge arms must be fully seated onto the roller pins.

3.Fully open the oven door (horizontal with floor - Fig. 1).

4.Push the door hinge locks up towards and into the oven frame on both left and right oven door hinges (Fig. 2) to the locked position; then close the oven door.

Oven door hinge locations with oven door fully open.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

21