Setting the Clock
Clock
The ,o,o_ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash along with "PF" (power failure, See Figure 1).
When PF appears in the display and 12:00 is flashing, press _ _
_,_i_,,• No sound will be heard,
but after 10 seconds a beep will sound and PF will disappear.
INSTRUCTIONSPRESS
To set the clock (example below for 1:30)
Press | .o,_o_."CLO" | will appear in the display (Figure 2). |
| Clock | ||
| Horl,_ge | |||||
2. Press | 1 | 3 | 0 | pads to set the time of day to 1:30 (Figure | 13 | 0 |
3). "CLO" will stay in the display. Press 6_ART• CLO will
disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. | Press | and hold ,_,_o'for 7 seconds | (Figure 3). After 7 seconds, | c!,_ for 7 seconds |
| "12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display |
| ||
| and the control will beep once. |
|
| |
2. | Press | _I[_, to switch between the | 12 and 24 hour time of day | Clean |
Nettewr | ||||
| display. The display will show either "12Hr" (Figure 5) or "24Hr" |
| ||
| (Figure6). |
|
| |
3. | Press | to accept the change | or press _%_,'tof reject the | or |
change.
4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.
Figure 1
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6