Frigidaire 318200404 manual Oven Light, Surface Light, Elements are Cool

Page 7

Installation Instructions (continued)

To level the range:

UNLOCK

LOCK

LOCKING THE FRONT ROLLERS (some of the 30” models only)

1.Use a 1-1/4” open end key or an adjustable wrench to equally unscrew the four leveling legs two to three turns each.

2.Install an oven rack in the center of the oven.

3.Move the range to its final position, then put a spirit level on the rack to check for levelness. Take two readings, one with the level placed diagonally first in one direction, and then the other.

4.Use the 1-1/4” key or wrench to adjust the leveling legs. Turn each one until the range stands firm without wobbling.

5.Some models are supported by smooth glide rollers to facilitate moving.

If floor is flat and level, open the drawer and lower the front roller locking levers (some models) to prevent the range from moving.

If floor is not flat or level or if this model has rollers without locking levers, use the 4 leveling legs to level, support and prevent the range from moving.

Oven Light

Do not turn the oven light on during the self-cleaning cycle.

High temperature will reduce lamp life.

On some models an interior oven light will turn on automatically when the oven door is opened.

The oven light may be turned on when the door is closed by using the oven light switch located on or underneath the control panel.

On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.

THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.

To replace the light bulb:

CAUTION: BE SURE OVEN IS COOL.

1.Turn the power off at the main source.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Replace bulb with a 40 watt appliance bulb only.

4.For self-cleaning oven, press wire holder to one side to release glass shield, change bulb and be sure to replace glass shield.

Surface Light

(some models)

BE SURE ALL SURFACE ELEMENT CONTROL KNOBS ARE TURNED TO OFF “ ”

AND ELEMENTS ARE COOL.

Use switch located on or underneath the control panel to turn the surface light ON/OFF.

Replace the surface light, if after repeated attempts to turn it on you are not successful.

SURFACE LIGHT REPLACEMENT (some models)

To remove and replace the fluorescent light:

1.Place your fingers under the tube at approx. 20.3 cm (8”) from each end.

2.To remove, turn the tube 90° then pull it down and out of its sockets.

3.To replace the tube, engage the new tube into the sockets, then rotate and snap the tube in place. Turn on the surface light to make sure it will lit.

General 5 Information

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Electric Ranges N e r ’ s I d e Warrantor Frigidaire Parts and ServiceWarranty Applies to Warranty does not Apply toN e r a l I n f o r m a t i o n Do not Touch Surface UNITS, Areas Near These Important Instructions for UsingYour Cooktop Important Instructions for Cleaning Your RangeImportant Instructions for Using Your Oven SELF-CLEANING OvensLeveling Installation InstructionsClearances and Dimensions LocationSurface Light Oven LightElements are Cool Good Setting Surface ControlsCircuit Protection Selecting Surface Cooking UtensilsConvection notes Convection Roasting some modelsAir Circulation in the Oven Convection CookingBaking Problems and Solutions Chart Indicator LightOven Baking Broiling Oven SettingsTypes of Heating Units Used Ceramic Glass Cooktop some modelsUSE and Care of Glass Surface HOT Surface Indicator LightSpecial Caution for Aluminum Foil Aluminum Cooking Utensils Things to RememberDo USE on Ceramic Glass Cooktop Cleaning Materials for Ceramic Glass CooktopDo not USE on Ceramic Glass Cooktop Coil Surface Elements some models Cleaning the ApplianceSurfaces Cleaning Agents Instructions Control PanelPorcelain Enamel Cooktop Cleaning Porcelain enamel cooktop cleaning instructionsDaily Cleaning Adhere to the following cleaning precautions Cleaning the Regular Oven Non self-clean ovenCleaning the Self-Clean Oven some models Preparing the Oven for Self-CleaningAutomatic Lock OFF of the Surface Elements What to Expect During CleaningSetting the Controls for a Clean Cycle To Remove and Replace the Oven DoorTo replace the external door panel Removable Outer Door Glass Panel some modelsTo Remove/Replace Storage Drawer To remove the external door glass panelStaple or clip original invoice here Problem Possible Cause / Solution InstallationRange does not Operate Surface Units Range does not OperatePoor Baking Results Avoid Transportation Damage to Your Range BroilingSetting Warmer Drawer Controls To Remove Warmer Drawer General CleaningTo Replace Warmer Drawer Cuisinières Électriques Guide de ’utilisateur LA Garantie NE Sapplique PAS Frigidaire Pièces ET ServiceGarant LA Garantie SappliqueF o r m a t i o n s g é n é r a l e s Importantes Mesures DE Sécurité Fours Autonettoyants Pour Surface DE Cuisson Vitrocéramique SeulementInstructions Importantes Pour L’UTILISATION DE Votre Four Conservez CES InstructionsVUE DE ’AVANT Côté Espaces prévus et dimensionsEmplacement NivellementCertain modèles Pour mettre la cuisinière de niveau Instructions d’installation suiteLampe DE Surface Installée Lampe du fourRéglage Type de cuisson Coupe-circuit de protectionBON MauvaisOption disponible avec certains modèles Rôtissage par convection certains modèlesCirculation d’air dans le four Cuisson par convectionCuisson au four Voyants lumineuxRéglage du four Cuisson au grilTypes DE Foyers Utilisés Surface de cuisson vitrocéramique certains modèlesEntretien DE LA Surface DE Cuisson Surface de cuisson vitrocéramique certains modèles suiteVoyant Avertisseur DE Surface Chaude Points À SE RappelerAvertissement Certains modèles suiteComment Nettoyer LA Surface DE Cuisson Vitrocéramique NE PAS Utiliser SUR LA Surface DE Cuisson VitrocéramiqueSurface de cuisson à foyers spiralés certains modèles Tableau des commandesNettoyage de l’appareil Nettoyage extérieurNettoyage DE LA Surface DE Cuisson EN Émail Vitrifié Nettoyage de l’appareil suiteNettoyage Quotidien Prenez les précautions de nettoyage qui suivent Nettoyage du four régulier four non autonettoyantNettoyage du four autonettoyant certains modèles Préparation du four avant l’autonettoyageTable de cuisson levable certains modèles Enlever et réinstaller la porteRéglage des commandes du four Ce qui peut survenir durant l’autonettoyagePour retirer la vitre extérieure de la porte Pour réinstaller la vitre extérieure de la portePorte avec vitre extérieure démontable certains modèles Retirer/replacer le tiroir de rangementBrocher ici votre facture LA Cuisinière NE Fonctionne PAS Problèmecause Possible / SolutionSurface DE Cuisson LA Cuisinière NE Fonctionne PAS suiteMauvais Résultats DE Cuisson AU Four Cuisson AU Gril Problème Cause Possible / SolutionÉvitez D’ENDOMMAGER L’APPAREIL Durant SON Transport Réglage des Commandes duTiroir-réchaud Nettoyage général Suite

318200404 specifications

The Frigidaire 318200404 is a high-quality replacement oven igniter designed to enhance the functionality and reliability of gas appliances. Its design ensures that it ignites the gas burner effectively, delivering consistent performance vital for cooking and baking. This igniter is primarily used in various Frigidaire gas ranges and ovens, making it an essential component for maintaining optimal cooking conditions.

One of the main features of the Frigidaire 318200404 is its durable construction. Made from high-temperature resistant materials, it can withstand the intense heat produced in the oven, ensuring longevity and reliability. This durability is crucial, as igniters are subjected to thermal stress during regular use. Additionally, the Frigidaire igniter is designed to provide a stable ignition source, minimizing the risk of gas build-up, which can occur if the igniter fails to activate promptly.

The technology behind the Frigidaire 318200404 involves a ceramic insulator combined with a metal filament. This combination allows for efficient heat generation, resulting in a quicker and more reliable ignition process. The igniter is engineered to provide a slow build-up of heat, which is ideal for igniting larger burners, ensuring that meals cook evenly and reduce the likelihood of burning.

Another characteristic of the Frigidaire 318200404 is its ease of installation. It typically features a straightforward plug-in design that allows homeowners and technicians to replace faulty igniters with minimal tools and effort. This ease of replacement reduces downtime for ovens and ensures that cooking appliances remain functional with little disruption to the household routine.

Moreover, the 318200404 igniter is compatible with various Frigidaire models, making it a versatile choice for many users. Proper maintenance of the oven igniter is crucial, as regular inspections can prevent significant issues and extend the lifespan of the appliance.

In summary, the Frigidaire 318200404 is a reliable and efficient igniter that plays an essential role in gas cooking appliances. Its durable construction, advanced technology, and easy installation make it an ideal choice for homeowners looking to maintain the performance of their ovens and ranges. Proper attention to the igniter can significantly enhance the overall cooking experience.
Top Page Image Contents