SURFACE COOKING
Electric Ignition
Your surface burners are lighted by electric ignition, eliminating the need for standing pilot lights with constantly burning flames.
In case of a power failure, you can light the surface burners on your range with a match. Hold a lighted match to the burner, then turn the knob to the LITE position. Use extreme caution when lighting burners in this manner.
Surface burners in use when an electrical power failure occurs will continue to operate normally.
Surface Burner Controls
The knobs that turn the surface burners on and off are located on the lower control panel in front of the burners.
The two knobs on the left control the left front and left rear burners. The two knobs on the right control the right front and right rear burners.
To Light a Surface Burner
Push the control knob in and turn it counterclockwise to LITE. You will hear a little “clicking”
After the burner ignites, turn the knob to adjust the flame size.
—
After Lighting a Burner
Check to be sure the burner you turned on is the one you want to use.
Do not operate a burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat.
Be sure the burners and grates are cool before you place your hand, a pot holder, cleaning cloths or other materials on them.
—
8
.—