GE JSP47, JSP42 Instructions Safety Instructions, Consumer Support Troubleshooting Tips Care

Bottom edge of slot

Hinge arm

Notch stop

Instructions Safety Instructions

Care and cleaning of the range.

Painted Surfaces

Painted surfaces include the door, top of	Do not use commercial oven cleaners,
the control panel and the drawer front.	cleaning powders, steel wool or harsh
Clean these with soap and water or a	abrasives on any painted surface.
vinegar and water solution.

Control Panel

■ Clean up splatters with a damp cloth.	■ Remove heavier soil with warm
■ You may also use a glass cleaner.	soapy water.
	■ Do not use abrasives of any kind.

and Cleaning Operating

The gasket is designed with a gap at the bottom to allow for proper air circulation.

Do not rub or clean the door gasket— it has an extremely low resistance to abrasion.

If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.

Cleaning the Oven Door

To clean the inside of the door:

■Because the area inside the gasket is cleaned during the self-clean cycle, you do not need to clean this by hand.

■The area outside the gasket and the door liner can be cleaned with a soap-filled steel wool or plastic pad, hot water and detergent. Rinse well with a vinegar and water solution.

To clean the outside of the door:

■Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass

on the outside of the door. Do not let water drip into the vent openings.

■If any stain on the door vent trim is persistent, use a soft abrasive cleaner and a sponge-scrubber for best results.

■Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.

■Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door.

Consumer Support Troubleshooting Tips Care

Slot

Hinge lock

Pull hinge locks down to unlock.

Removal position

22

Lift-Off Oven Door

The door is very heavy. Be careful when removing and lifting the door.

To remove the door:

Fully open the door.

Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat-blade screwdriver, may be required.

Firmly grasp both sides of the door at the top. Do not lift the door by the handle.

Close door to the door removal position, which is halfway between the broil stop position and fully closed.

Lift door up and out until the hinge arm is clear of the slot.

To replace the door:

Firmly grasp both sides of the door at the top. Do not lift the door by the

handle.

With the door at the

same angle as the removal position, seat the notch stop of the hinge arm

into the bottom

edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot.

Fully open the door until it is parallel to the floor. If the door will not fully open, the notch stop is not seated correctly in the bottom edge of the slot. Repeat step 2 if necessary.

Push the hinge locks up against the front frame of the oven cavity to the locked position.

Hinge arm

Hinge lock

Push hinge locks up to lock.

Close the oven door.