Using the clock, timer and control lockout

Using the clock, timer and control lockout.

ge.com

Safety

Make sure the clock is set to the correct time of day.

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

Press the CLOCK pad.

Press the number pads.

Press the START pad.

Instructions

The timer is a minute timer only.

The timer does not control oven operations. The maximum setting on the timer is 9 hours and 59 minutes.

To Set the Timer

Press the KITCHEN TIMER ON/OFF pad.

Press the number pads until the amount of time you want shows in the display. For example, to set 2 hours and 45 minutes, press 2, 4 and 5 in that order.

If you make a mistake press the KITCHEN TIMER ON/OFF pad and begin again.

Press the START pad.

After pressing the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed. Seconds will not be shown in the display until the last minute is counting down.

When the timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

Operating Instructions Care and

To Reset the Timer

If the display is still showing the time remaining, you may change it by pressing the KITCHEN TIMER ON/OFF pad, then press the number pads until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by pressing the KITCHEN TIMER ON/OFF pad and then pressing the number pads to enter the new time you want.

Cleaning

To Cancel the Timer

Press the KITCHEN TIMER ON/OFF pad twice.

Troubleshooting

Control Lockout

Your control will allow you to lock out the press pads so they cannot be activated when pressed.

To lock/unlock the controls:

Press the 9 and 0 pads at the same time for 3 seconds, until the display shows LOC ON.

To unlock the control, press the

9and 0 pads at the same time for

3seconds, until the display shows

LOC OFF.

When this feature is on and the press pads are pressed, the control will beep and the display will show LOC ON.

■The control lockout mode affects all press pads. No press pads will work when this feature is activated.

■The adjustment will be retained in memory after a power failure.

Tips Consumer Support