Instructions
Care and cleaning of the range.
Operating Instructions Safety
The gasket is designed with a gap at the bottom to allow for proper air circulation.
Do not rub or clean the door gasket— it has an extremely low resistance to abrasion.
If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.
Cleaning the Oven Door
To clean the inside of the door:
■Soap and water will normally do the job. Heavy spattering or spillovers may require cleaning with a mild abrasive cleaner.
Do not allow food spills with a high sugar or acid content (such as tomatoes, sauerkraut, fruit juices or pie filling) to remain on the surface. They may cause a dull spot even after cleaning.
If necessary, you may use an oven cleaner. Follow the package directions.
■Clean the inside of the oven window with a mild
To clean the outside of the door:
■Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door. Do not let water drip into the vent openings.
■Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.
■Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door.
Lift-Off Oven Door
Care and Cleaning
Slot
Hinge lock
Pull hinge locks down to unlock.
The door is very heavy. Be careful when removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small
With the | Bottom | Hinge arm | |
door at the | edge of | ||
| |||
same angle | slot |
| |
|
| ||
as the |
|
| |
removal position, |
| ||
seat the |
| Indentation | |
indentation of |
| ||
the hinge arm |
| ||
into the bottom edge of the hinge | |||
slot. The notch in the hinge arm |
must be fully seated into the bottom of the slot.
Support Troubleshooting Tips
Removal position
Firmly grasp both sides of the door at the top.
Close door to the door removal position, which is halfway between the broil stop position and fully closed.
Lift door up and out until the hinge arm is clear of the slot.
To replace the door:
Firmly grasp both sides of the door at the top.
Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.
Push the hinge locks up against the front frame of the oven cavity to the locked position.
Hinge lock
Hinge arm
Consumer
Push hinge locks up to lock.
Close the oven door.
20