GE JGBP25, JGBP26, JGBP27, JGBP28, JGBP29, JGBP31, JGBP32, JGBP33 manual

Page 25

ge.com

The oven door must be closed and all controls set correctly for the cycle to work properly.

How to Delay the Start of Cleaning (on some models)

Safety Instructions

You can set the oven control to delay-start the oven, clean for a specific length of time and then turn off automatically.

Make sure the clock shows the correct time of day.

Follow the directions in the Before a Clean Cycle section.

Latch the door.

NOTE: Never force the latch. If the oven is too hot, you will not be able to slide the latch. Allow the oven to cool.

Touch the Self Clean pad.

Touch the + or – pads to set the

Clean Time.

The Clean Time is preset for 4 hours and 20 minutes. You can change the Clean Time to any time between 3 and 5 hours, depending on the amount of soil in your oven. If a different Clean Time is desired, touch the + or – pads until the desired Clean Time is displayed.

Change the Start Time by touching the + or – pads. The start time will appear in the display.

Touch the Start/On pad.

The self-clean cycle will automatically begin at the time set.

While the oven is self-cleaning, you can touch the Clock pad to display the time of day. To return to the clean countdown, touch the Self Clean pad.

The oven shuts off automatically when the clean cycle is complete, and 0:00 will flash in the display.

Slide the latch handle to the left as far as it will go and open the door.

Instructions

Operating

Care and Cleaning

Touch the Start Time pad.

To Stop a Clean Cycle (on some models)

Touch the Clear/Off pad.

Wait until the oven has cooled below the locking temperature to unlatch the door. You will not be able to open the door right away unless the oven has cooled below the locking temperature.

Installation Instructions

After a Clean Cycle (on some models)

You cannot set the oven for cooking until the oven is cool enough for the door to be unlatched.

You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap- filled scouring pad and rinse thoroughly with

a vinegar and water mixture.

These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

■You cannot set the oven for cooking until the oven is cool enough for the door

to unlock.

■While the oven is self-cleaning, you can touch the Clock pad to display the time of day. To return to the clean countdown, touch the Cooking Time pad.

■If the shelves become hard to slide, apply a small amount of vegetable oil or cooking oil to a paper towel and wipe the edges of the oven shelves with the paper towel.

Troubleshooting Tips Consumer Support

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Write the model and serial numbers here Model # Serial # Ge.comWhat to do if YOU Smell GAS Ge.com Installation InstructionsSafety Precautions Instructions Surface BurnersCook Meat and Poultry THOROUGHLY… Operating Instructions Electric Warming Drawer on some modelsHow to Select Flame Size Using the gas surface burnersBefore Lighting a Gas Burner Sealed Gas BurnersTop-of-Range Cookware Case of Power FailureCare Using the oven controlsOven Temperature Knob on some models Oven Vent Before you begin…Preheating and Pan Placement How to Set the Oven for Baking or RoastingTroubleshooting Tips Consumer Support Aluminum FoilHow to Set the Oven for Broiling Using the ovenBroiling Guide Hi BroilTo Set the Timer Using the clock and timer. on some modelsTo Set the Clock To Turn Off the Clock DisplayTo Cancel the Timer To Reset the TimerPower Outage Touch the Kitchen Timer On/Off pad twiceHow to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopHour Shut-Off Special features of your oven control. on some modelsHow to Set for Regular Baking/Roasting Using the Sabbath Feature. on some modelsDesigned for use on the Jewish Sabbath and Holidays Operating Instructions To Adjust the Thermostat on some models Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat on models with an Oven Temp Knob Care and CleaningOn Signal Light When Using the Warming DrawerTo Crisp Stale Items Temperature Selection ChartBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning To Stop a Clean Cycle on some models How to Delay the Start of Cleaning on some modelsAfter a Clean Cycle on some models Standard Twin Burner Assemblies on some models Care and cleaning of the rangeInstructions Burner caps Burner Caps and HeadsCooktop Surface Burner GratesStainless Steel Surfaces on some models Lift-Off Oven Door To clean the inside of the doorOven Bottom Removable Kick Panel on some models Removable Storage Drawer on some models Safety InstructionsRemovable Warming Drawer on some models Lower Control Panel Front Manifold Panel and Knobs Oven Air VentsTo raise the cooktop Oven Shelves Oven Light ReplacementDo not remove any screws to remove the cover To replace coverPart Included For Your SafetyTools YOU will Need Materials YOU MAY NeedInstallation Instructions Dimensions and Clearances Location ANTI-TIP DeviceProvide Adequate GAS Supply Connect the Range to GASInstallation Instructions Rigid Pipe Hookup Options Pressure regulator Manifold pipe Electrical Requirements Electrical ConnectionsSeal the Openings Check Ignition of Surface BurnersCheck Ignition of Oven Burner To remove the oven bottom Leveling the RangeWhen ALL Hookups are Completed Installing the ANTI-TIP DeviceBefore you call for service… See the Care and cleaning of the range section See the Using the clock and timer sectionSee the Installation of the range section Oven temperatureClean cycle After a clean cycle Oven not clean afterSelf clean light on When trying to set aDisplay goes blank Power outageDisplay flashes Unable to getCare and Cleaning We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Looking For Something More? AccessoriesWhat GE Will Not Cover GE Will ReplaceOne Year Mabe Will Replace Care and CleaningWhat Mabe Will Not Cover Parts and Accessories Schedule ServiceConsumer Support GE Appliances Website Real Life Design Studio
Top Page Image Contents