GE 164D3333P150 owner manual Anti-Tip Bracket Installation, Leveling the Range, Final Check

Page 40

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

8 Anti-Tip Bracket Installation

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the Important Safety Information and the instructions that fit your situation before beginning installation.

WARNING

■Range must be secured by Anti-Tip bracket supplied.

■See instructions to install (supplied with bracket).

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Bracket	Wall plate
Screw must
enter wood
or metal

Typical installation of anti-tip bracket attachment to wall.

9 Leveling the Range

The range must be level. Leveling feet are located at each corner of the base of the range. Remove the storage drawer or kick panel (depending on your model) and using channel locks, rotate the leveling feet in and out as required to level the range. (For instructions on how to remove and replace the storage drawer or the kick panel, see the Care and cleaning of the range section.)

On some models, there are plastic covers which may be removed for easy adjustment (just squeeze and pull).

One of the rear leveling feet will engage the Anti-Tip bracket (allow for some side to side adjustment). Allow a minimum clearance of 1/8″ between the range and the leveling foot that is to be installed into the Anti-Tip bracket.

Check the range for proper installation into the Anti-Tip bracket by removing the kick panel or storage drawer and inspecting the rear leveling leg. Make sure it fits securely into the slot.

10 Final Check

Be sure all range controls are in the OFF position before leaving the range.

40

Image 40

Contents GE Appliances GE Answer CenterStaple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here DrawerGE & You Service Partnership All ranges can tip and injury could result Or using a ventilation fan or hoodAccording to local, state and federal codes Safety Precautions Safety Information Instructions Troubleshooting Tips Customer Service Cook Meat and Poultry THOROUGHLY…Oven SELF-CLEANING Oven Radiant Surface Units Cleaning the glass Cooktop section REMEMBER… Using the surface units How to SetIndicator Lights Dual Surface Unit Switch on some modelsAbout the radiant surface units… Do not use the surface as a cutting boardSelecting types of cookware Using the oven controls Customer Service Troubleshooting TipsClean Light Oven Temperature KnobOven on Light Preheated LightUsing the oven How to Set the Oven for Baking or RoastingBefore you begin… Type of margarine will affect baking performanceHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Broiling guide CommentsUsing the clock and timer Automatic Stop Make sure the oven clock shows the correct time of dayPress Cook Time ON/OFF Press Start Time ON/OFFFor Models with Pads and an Oven Temperature Knob For Models with Only an Oven Temperature KnobTips Customer Service Using the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning Customer Service TroubleshootingAfter a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Care and cleaning of the range Control Panel and KnobsOven Vent Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Do not lift the door by the handleOven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverTo remove the storage drawer Broiler Pan & GridTo replace the storage drawer Cleaning the glass cooktop Daily CleaningFor heavy, burned-on soil National Parts CenterSpecial Care Installation of the range Installation Instructions for future useWiring must conform to National Electric Codes Read these instructions completely and carefullyPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Be installed before reinstalling the rear range wiring coverWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Connector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Troubleshooting TipsBlank or indicator When range isFrequent cycling Off and onFood does not bake Or roast properlyFood does not Broil properly At BroilOven temperature Clock and timerSelf-clean Self-clean cycleOven not clean After a clean cycleClean light To CleanIs on when you Power outageWant to cook A numberGE Electric Range Warranty Five Years Replacement glass cooktop if it should crack dueWe Will Replace, At No Charge To You What GE Will Not CoverIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC