GE 164D3333P150 owner manual Wire Power Cord Installation, Do not remove ground strap connection

Page 36

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

4 3-Wire Power Cord Installation

WARNING: The neutral or ground wire of the power cord must be connected to the neutral terminal located in the center of the connector block. The power leads must be connected to the outside (brass colored) terminals.

Remove the 3 wire terminal screws from the connector block. Insert screws through each power cord terminal ring and into the connector block until the screws engage the nuts. Be certain that the center wire is connected to the center screw of the connector block. Tighten screws securely.

Do NOT remove ground strap connection.

Connector block

Neutral terminal

Ground strap

Power cord

Image 36

Contents GE Appliances GE Answer CenterStaple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here DrawerGE & You Service Partnership Or using a ventilation fan or hood All ranges can tip and injury could resultAccording to local, state and federal codes Safety Precautions Safety Information Instructions Troubleshooting Tips Customer Service Cook Meat and Poultry THOROUGHLY…Oven SELF-CLEANING Oven Radiant Surface Units Cleaning the glass Cooktop section REMEMBER… Using the surface units How to SetIndicator Lights Dual Surface Unit Switch on some modelsAbout the radiant surface units… Do not use the surface as a cutting boardSelecting types of cookware Using the oven controls Customer Service Troubleshooting TipsClean Light Oven Temperature KnobOven on Light Preheated LightUsing the oven How to Set the Oven for Baking or RoastingBefore you begin… Type of margarine will affect baking performancePreheating and Pan Placement How to Set the Oven for BroilingAluminum Foil Broiling guide CommentsUsing the clock and timer Automatic Stop Make sure the oven clock shows the correct time of dayPress Cook Time ON/OFF Press Start Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobTips Customer Service Using the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning Customer Service TroubleshootingHow to Delay the Start of Cleaning After a Clean CyclePress the Start Time ON/OFF pad Care and cleaning of the range Control Panel and KnobsOven Vent Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Do not lift the door by the handleOven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverBroiler Pan & Grid To remove the storage drawerTo replace the storage drawer Cleaning the glass cooktop Daily CleaningFor heavy, burned-on soil National Parts CenterSpecial Care Installation of the range Installation Instructions for future useWiring must conform to National Electric Codes Read these instructions completely and carefullyPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Be installed before reinstalling the rear range wiring coverWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Connector block terminal Bare wire Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… Troubleshooting TipsBlank or indicator When range isFrequent cycling Off and onFood does not bake Or roast properlyFood does not Broil properly At BroilOven temperature Clock and timerSelf-clean Self-clean cycleOven not clean After a clean cycleClean light To CleanIs on when you Power outageWant to cook A numberGE Electric Range Warranty Five Years Replacement glass cooktop if it should crack dueWe Will Replace, At No Charge To You What GE Will Not CoverService Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC