Bosch Appliances HGS245UC, HGS246UC manual Nectingthe electricam power, Convert Pressure Regulator

i, CAUTION: TurnoffGasand Emectridty

Before Proceedingwith the conversion;shut off

the{)assuppmytotheappliancepriortodiscono

nectingthe electricam power,

Shutofftheoutsidepropanetankgas valvetotherange,Re=

move range power cord from electrical outlet or turn breaker off at breaker box, and turn all control knobs to the "OFF" posi= tion.

Figure 1

Convert Pressure Regulator

Pin Position

for Propane

I

Pin\

Position

Gas

2° Convert Pressure Regulator from 5" W°C° to 10" W°C°

!.Remove Warming Drawer; Pull drawer out until stop is reached. Push clip on right side up and clip on left side down. Pull drawer the rest of the way out.

2, Remove cover plate from interior back wall by removing single screw on left side of panel

3.Remove the hexagon cap from the top of the regulator with an adjustable wrench.

4.Pop out the plastic stem in the cap and turn it over pressing it firmly in place so that the letters"LP" can now be seen upright in the stem, rather than "NAT".

5.Replace the cap and button assembly into the top of the regulator sealing it firmly. Make certain spring is still in place (See Fig. !). DO NOT OVER TORQUE.

6.Install the FOIL CONVERSION STICKER on the back side of the cover plate so that it appears on the back side of range next to the regulator,

PRESSUREREGULATORVIEW

Figure 2

Remove Grate, Cap and Base

Burner Cap_ d:

Burner Base--_)

Orifice

3, Repmace Main Cooktop Orifices

Remove Grates_ Burner Caps and Burner Bases, Remove

burnergratesand burnercaps,Unscrew 2 T20 screwsinside

each base and remove burner bases (See Figure 2). Reinsert screws in jet holder to hold tubing assembly" in place.

Remove Natural Gas Cooktop Orifices.Insertthesocket

driver with 3" minimum extension into the jet holders to re- move existing orifices. Place the old orifices in the space pro- vided on page 5 in case future conversion back to natural gas is necessary.

AssemMe LP Cooktop Orifices, Place in cooktop exactly as layed out in the cover ofthB manual (also shown in Figure 3). If the orifices become separated from the cover, placement can be determined by matching the number stamped into the orifice with the placement specifications displayed in Figure 4. Place the new orifice into the socket then insert each orifice into its respective threaded hole in the jet holder. Tighten until the orifice stops turning. DO NOT OVERTIGHTEN.

Figure	3
LP Cooktop Orifice	Placement
Left Rear Burner :	Right Rear Burner :
! 1,000 BTUIh 101	5,000 BTU/h 70

Left Front B_N	T 6_
	Right Front Burner -
7,500 BTU/h 86	!5,000 BTUih I:_B