Installation Instructions
ENGLISH
TABLE OF CONTENTS |
|
|
| page | |
|
| |
Introduction | 1 | |
Tools you will need | 1 | |
Power requirements | 1 | |
Choosing oven location | 1 | |
Steps for installation | 1 | |
Technical data | 2 | |
|
| page |
Installation notes | 2 | |
Wall or under counter installation, single oven | 3 | |
Wall installation double oven | 3 | |
Flush installation | 4 | |
Electrical supply | 5 | |
Wiring requirement | 5 | |
|
| page |
Connecting to 208V circuit | 5 | |
Electrical connections | 6 | |
6 | ||
6 | ||
Final check list | 6 | |
IMPORTANT: Save these instructions for the local electrical inspector use.
INSTALLER: Please leave this manual with owner for future reference.
OWNER: Please keep this manual for future reference.
WARNING
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage,
personal injury or death.
INTRODUCTION
Please read these instructions COMPLETELY AND CAREFULLY. They will save you time and effort and help to ensure optimum oven performance.
Be sure to observe all WARNINGS. These installation instructions are intended for use by a qualified installer.
In addition to these instructions, the oven shall be installed:
In the United States, in accordance with the National Electric Code/State and Municipal codes and/or local codes.
In Canada, in accordance with Canadian Electric Code
codes and/ or local codes.
These shall be carefully followed at all times.
NOTE: IF INSTALLING YOUR OVEN IN CANADA PLEASE CHECK TO MAKE SURE THAT YOU HAVE A MODEL WITH THE US AND CANADIAN LISTING
MARK, AS SHOWN ABOVE:
Mark as shown above means the oven complies with both US and CANADIAN Standards.
TOOLS YOU WILL NEED
The following tools are needed to install your new oven:
Tape measure and straightedge or ruler
Pencil
Phillips screwdriver
Level
Wire cutters and wire stripper
Hand or saber saw
1” (2,5cm) Hole saw
Drill and drill bit
Safety gloves and goggles
Volt meter
PACKAGING
Remove all tape and packaging before using the oven. Destroy the packaging after unpacking the oven following the rules in force in your town. Never allow children to play with packaging material.
POWER REQUIREMENTS
The oven must be supplied with the proper voltage and frequency. The oven is manufactured to be connected to a
electrical supply on a separate circuit fused on both sides of the line. If a ust be used, see Connecting to
, in this manual. A circuit breaker or time delay
fuse, sized not to exceed the circuit rating of the appliance specified on the rating plate located on the frame behind the door of the oven is recommended (see figure at page 5).
The oven must be supplied with copper or alumimum wires. If aluminum wire is provided to connect oven to branch circuit, UL listed connectors for joining copper and aluminum must be used. Follow instructions provided with connectors.
It is recommended that you have the electrical wiring and
CHOOSING OVEN LOCATION
Carefully select the location where the oven will be placed. The oven should be located for convenient use in the kitchen, but away from strong drafts.
Strong drafts may be caused by open doors or windows, or by heating and/or air conditioning vents or fans. Make sure that electrical power can be provided to the location selected.
STEPS FOR INSTALLATION
The following pages provide the necessary information for proper installation of the oven and are arranged as follows:
Technical Data
Installation Cutout Dimensions, Required Clearances and Mounting instructions for:
-Under counter Installation, Single Oven
-Wall Installation, Single Oven
-Wall Installation, Double Oven
Electrical Supply and Wiring Requirements, Programming required if connecting to Volt Circuit. Electrical Connections for
Final Checklist
3