M21 ,,-,I

After use, return the hex wrench to the storage position.

n \

Switch action

To prevent the trigger from being acciden- tally pulled, a lock-off lever i s provided.

To start the tool, slide the lock-off lever in the direction of the arrow and pull the trigger. Release the trigger to stop.

Hex wrench A

Lock-off lever

h c t i w S ;

trigger

CAUTION :

Before inserting the battery cartridge into the tool, always check to see that the trigger switch actuates properly and returns to the "OFF" position when released.

Sterilization of rasp blade, holder and drive shaft

The rasp blade, holder and drive shaft must be sterilized each time the tool is used and between each horse, to prevent the spread or cross infection of any disease, virus, etc. They can be sterilized by boiling or in a disinfectant (which will not harm the horse's health) without removing them from the tool. But it is recommended rather that the sterilization be carried out by a suitable sterilizing unit after removal from the tool. In this case, the hex wrench to be used for assembling them also must be sterilized.

CAUTION :

When sterilizing the rasp blade, holder and drive shaft by boiling or in a disinfectant, be careful not to splash boiling water or disinfectant on your hands, the tool, etc.