BASIC ENGINE
Figure 2. Engine Controls & Components
ENGINE COMPONENTS
The engine (Figure 2) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers Engine manual for instructions & details of operation and servicing.
5. | Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop |
| the flow of fuel. |
6. | Choke Lever – Used in the starting of a cold engine, or in |
| cold weather conditions. The choke enriches the fuel |
| mixture. |
1. Fuel Filler Cap – Remove this cap to add unleaded | 7. Air Cleaner – Prevents dirt and other debris from entering | |
the fuel system. Remove | ||
gasoline to the fuel tank. Make sure cap is tightened | ||
cannister to gain access to filter element. | ||
securely. DO NOT over fill. | ||
|
WARNING
Add fuel to the tank only when the engine is stopped and has cooled down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up and the area surrounding the engine is dry.
2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward - SLOW, lever back toward operator - FAST).
3. | Engine ON/OFF Switch – ON position permits engine |
| starting, OFF position stops engine operations. |
4. | Recoil Starter (pull rope) – |
| the starter grip until resistance is felt, then pull briskly and |
| smoothly. |
NOTICE
Operating the engine without an air filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.
WARNING
Engine components can generate extreme heat.To prevent burns,DONOTtouch these areas while the engine is running or immediatelyafteroperating.NEVERoperate the engine with the muffler removed.
8. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.
9. Muffler – Used to reduce noise and emissions.
10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.
MVC80VH/VHW PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #3 (1/13/11) — PAGE 15