Multiquip MVC80VH/VHW manual Startup/Operation

Page 19

STARTUP/OPERATION

6.If the engine has started, slowly return the choke lever (Figure 11) to the CLOSED position. If the engine has not started, repeat steps 1 through 5.

7.Beforethecompactorisputintooperation,runtheenginefor 3-5 minutes.

8.Check for abnormal engine noises or fuel leaks.

Operation

CAUTION

Makesuretofollowallsafetyrulesreferencedinthesafety sectionofthismanualbeforeoperatingcompactor. Keep work area clear of debris and other objects that could cause damage to the compactor or bodily injury.

1.Once the engine has started, move the engine throttle lever quickly to the fast position.

2.With the throttle lever in the fast position, the engine speed should be around 2,300 RPM, therefore engaging the cen- trifugalclutch.

NOTICE

ALWAYS move the throttle lever quickly without hesitation, because increasing the engine speed slowly causes the clutch to slip.

5.Firmlygraspthecompactor'shandlebar withbothhands, the compactor will begin moving forward.

6.Slowly walk behind the compactor and be on the lookout for anylargeobjectsorforeignmatterthatmightcausedamage to the compactor or bodily injury.

7.Compactortravelingspeedmaydroponsoilswhichcontain clay, however there may be cases where traveling speed drops because the compaction plate does not leave the ground surface easily due to the composition of the soil.To rectify this problem do the following:

Check the bottom plate to see if clay or equivalent material has been lodged in the plate mechanism. If so, wash with water and remove.

Remember the compactor does not work as efficiently on clay or soils that have a high moisture content level.

If the soil has a high moisture level, dry soil to appropriate moisture content level or carry out compaction twice.

Stopping the Engine

NOTICE

NEVER stop the engine suddenly while working at high speeds.

Normal Shutdown

1.Place the throttle lever (Figure 12) in slow position, and listen for the engine speed to decrease.

2.Place the Engine ON/OFF switch (Figure 10) in the "OFF" position.

3.Place the fuel valve lever (Figure 9) in the "OFF" position.

Emergency Shutdown

1.Move the throttle lever quickly to the slow position, and place the Engine ON/OFF switch in the "OFF " position.

MVC80VH/VHW PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #3 (1/13/11) — PAGE 19

Image 19
Contents Model MVC80VH/VHW Proposition 65 Warning Page Component Drawings Table of ContentsOrdering parts has never been easier Parts Ordering ProcedureSafety Messages Safety InformationGeneral Safety Compactor Safety Fuel Safety Transporting Safety Specifications Compactor SpecificationsDimensions DimensionsDefinition of Plate Compactor General InformationWater Tank MVC-80VHW only ComponentsEngine Components Basic EngineBefore Starting InspectionClutch Pulley Vibrator Startup Place the Engine ON/OFF switch in the on positionOperation STARTUP/OPERATIONInspection and Maintenance ServiceTables MaintenanceEngine OIL Spark Plug Gap Changing Vibrator Oil Plate Compactor Storage Preparation for LONG-TERM StorageEngine Troubleshooting TroubleshootingEngine Troubleshooting Xxxxx only Not Used on Explanation of Codes in Remarks ColumnSpark Plug Suggested Spare PartsBelt Shock AbsorberNameplate and Decals Water Tank Contact MQ Parts DeptMQ/WATER Tank Main Body Assy Base Earth WireMain Body Assy Vibrating PlateVibrator Assy Vibrator AssyCase COVER/PULLEY Vibrating CaseWASHER, Lock M14 WASHER, Flat M14Water Tank Assy Pipe Holder Guard HookCAP, Water Tank Nylon NUT M10Cylinder Head Assy TUBE, Breather CLIP, Valve GuideGASKET, Cylinder Head COVER, HeadCylinder Barrel Assy SHAFT, Governor ARM Switch ASSY., OIL LevelGovernor Assy SLIDER, GovernorCrankcase Cover Assy GASKET, OIL Filler CAP GASKET, CrankcaseBEARING, Radial Ball Crankshaft Assy Crankshaft PISTON/RINGS Assy PIN, Piston BOLT, Connecting RODRing SET, Piston STD Piston STDCamshaft Assy Camshaft AssyARM, Valve Rocker SPRING, Weight ReturnSEAL, Valve Stem ROD, PushRecoil Starter Assy PLATE, Friction CASE, Recoil StarterREEL, Recoil Starter RATCHET, StarterFAN Cover Assy Alert UNIT, OIL COVER, FAN BlackPLATE, Side OIL Alert ShroudCarburetor Assy Float SET PLATE, Lever SettingGasket SET Valve SET, FloatAIR Cleaner Assy Collar B, AIR Cleaner COVER, AIR CleanerGROMMET, AIR Cleaner COLLAR, AIR CleanerMuffler Assy Muffler AssyDeflector CP MufflerPROTECTOR, Muffler PROTECTOR, LowerFuel Tank Assy FILTER, Fuel JOINT, Fuel TankTANK, Fuel Black GASKET, Fuel Filler CAPCooling FAN and Flywheel Assy NUT, Special 14MM FAN, CoolingPULLEY, Starter FlywheelIgnition Coil Assy Coil ASSY., Ignition WIRE, Stop Switch 370MMCAP Assy Control Assy SPRING, Governor HOLDER, WireARM, Governor ROD, GovernorLabels Assy MARK, Choke Gray MARK, Operator CautionFreight Policy Terms and Conditions of Sale PartsPage HERE’S HOW to GET Help