Multiquip manual MVC-40G Safety Message Alert Symbols

Page 8

MVC-40G — SAFETY MESSAGE ALERT SYMBOLS

FORYOUR SAFETY AND THE SAFETY OF OTHERS!

Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the Safety Messages and Operating Instructions could result in injury to yourself and others.

 

This Owner's Manual has been

 

developed to provide complete

NOTE

instructionsforthesafeandefficient

operation of the MQ Model MVC-

 

40GPlateCompactor.Refertothe

 

engine manufacturers instructions

 

fordatarelativetoitssafeoperation.

Before using this plate compactor, ensure that the operating individual has read and understands all instructions in this manual.

SAFETY MESSAGE ALERT SYMBOLS

The three (3) Safety Messages shown below will inform you about potential hazards that could injure you or others. The Safety Messages specifically address the level of exposure to the operator, and are preceded by one of three words: DANGER, WARNING, or CAUTION.

DANGER

You WILL be KILLED or SERIOUSLY injured if you DO NOT follow directions.

WARNING

You CAN be KILLED or SERIOUSLY injured if you DO NOT follow directions.

CAUTION

You CAN be INJURED if you DO NOT follow directions.

HAZARD SYMBOLS

Potential hazards associated with the operation of the MQ Model MVC-40G Plate Compactor. will be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols.

WARNING - Lethal Exhaust Gas Hazards

Engine exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled. NEVER operate this equipment in a confined area or

enclosed structure that does not provide ample free flow air.

DANGER - Explosive Fuel Hazards

Gasoline is extremely flammable, and its vapors can cause an explosion if ignited. DO NOT start the engine near spilled fuel or combustible fluids.

DO NOT fill the fuel tank while the engine is running or hot. DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system. Store fuel in approved containers, in

WARNING - Burn Hazards

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operations. Never operate the engine with heat shields or heat guards removed.

WARNING - Respiratory Hazards

ALWAYS wear approved respiratory protection when required.

PAGE 8 — MVC-40G PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #4 (06/06/07)

Image 8
Contents MVC-40G Page Page Table of Contents Order via Fax Dealers Only Parts Ordering Procedures Best Deal! Order via Internet Dealers Only MVC-40G Specifications Compactor SpecificationsMVC-40G Dimensions MVC-40G Plate Compactor DimensionsMVC-40G Safety Message Alert Symbols Always wear approved respiratory protection when requiredMVC-40G Safety Message Alert Symbols MVC-40G Rules for Safe Operation MVC-40G Rules for Safe Operation Loading and Unloading CraneMVC-40G General Information MVC-40G Components Plate Compactor MVC-40G Components Engine MVC-40G Inspection Before StartingEngine Oil Check Fuel CheckBelt Check Vibrator Oil CheckPlace the engine ON/OFF switch in the on position Starting the EnginePlace the engine fuel valve lever in the on position Place the throttle lever in the slow position idleMVC-40G Initial START-UP Stopping The EngineMVC-40G Operation OperationMVC-40G Maintenance Inspection and Maintenance ServiceTablesDaily Service Check engine oil, seeReinstalling the V-belt Changing Vibrator OilChecking and Replacing the V-Belt and Clutch Replacing the V-beltMVC-40G- Preparation for Long -TERM Storage Compactor StorageMVC-40G Troubleshooting Engine MVC-40G Troubleshooting Engine MVC-40G Troubleshooting Plate Compactor NO. Column Part NO. ColumnQTY. Column Remarks ColumnMVC-40G- Suggested Spare Parts To 3 UnitsMachine Safety Decals MVC-40G- Name Plate and DecalsMVC-40G- Nameplate and Decals Part Name QTY RemarksMVC-40G- Base and Handle Assy Part Name MVC-40G-VIBRATING Plate Andvibrator Assy Vibrating Plate MVC-40G- Engine Assy Part Name QTY BELT, A-27 BLUE/RPF-3270Robin EH09-2D Crankcase Assy Valve Guide O/S Robin EH09-2D Camshaft Assy PIN, Spring Robin EH09-2D Crankshaft and Piston Assy Spacer 0.8T Robin EH09-2D Intake Exhaust Assy Valve Spring Robin EH09-2D AIR Cleaner Assy Element SET Robin EH09-2D Muffler Assy Muffler Assy Robin EH09-2D Governor Assy Governor Lever Robin EH09-2D COOLING, and Starting Assy Robin EH09-2D COOLING, Starting Assy 210-49Robin EH09-2D Fueltank Assy Fuel Robin EH09-2D Carburetor Assy Throttle Valve Robin EH09-2D Electric Device Assy FLY Wheel CP Accessory Tool KIT Robin EH09-2D Accessorytool KIT Payment Terms Page Heres HOW to GET Help Your Local Dealer is