Before START-UP

MVH-702DRSC — BEFORE START-UP

1.Read this manual carefully and understand all functions of the machine before start-up.

2.The engine is located on front side of the machine and the aluminum oil tank is on the rear.

3.The operator should always keep a distance of 2 meters away from the machine.

4.The operator should always make sure that the machine will move in the opposite direction (away from him) when the machine is started.

5.In infra-red remote control operation, the farther the machine moves, the narrower the control area.

6.If the transmitter fails and during emergencies, pull the emergency stop lever (Figure 8) continuously until the machine completely stops.

Emergency

Stop Lever

Figure 8. Location of Emergency Stop Lever

Remote Control operation is not available in the following cases. Vibration stops automatically.

Operator stands within approximately 3 feet (1 m) of the machine.

Operator stands approximately 60 feet (18 m) or farther from the machine (approximately 40 feet (12 m) when far from the direct rays of the sun). Note that these distances may vary .

Operator stops sending control signals for more than one second.

The engine is overloaded. In the engine temperature increases, the vibration will automatically stop.

The engine stops automatically in the following cases.

Engine oil level is low.

Control unit fails to receive the operational signal for more than 30 seconds.

During engine or hydraulic oil warm-up, direct the transmitter to the body receiver to receive the operational signal. Operation starts only after the main switch of the transmitter is switched on.

SETTINGTHE OPERATIONAL CHANNEL

In cases where several machines operate in the same area, each machine should be transmitting in a different infra-red channel.Ten different channels can be set (0 to 9).See Table 2. To set the operational channel of a machine, do the following.

1.On the body of the machine, remove the receiver channel plug. See Figure 9. Using a screwdriver, set the channel number desired.

2.On the transmitter, remove the channel plug. See Figure 9. Using a screwdriver, set the channel number to the same one as the receiver (set in step 1).

Remove plug and adjust

MACHINE

Remove plug and adjust

TRANSMITTER

Figure 9. Setting Channels

Table 2. Channel Number Settings

TRANSMITTER	RECEIVER

0	0

1	1

2	2

3	3

4	4

5	5

6	6

7	7

8	8

9	9

PAGE 20 — MQ-MIKASA MVH-702DRSC COMPACTOR — PARTS & OPERATION MANUAL — REV. #1 (12/17/03)