Stow manual Stow T-30H Basic Engine, Initial Servicing

Page 14

STOW T-30H — BASIC ENGINE

Figure 3. Engine

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers engine manual for instructions & details of operation and servicing. The engine shown above is a HONDA engine, operation for other types of engines may vary somewhat.

Controls and Components

6. Choke Lever – Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.

7. Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter cannister to gain access to filter element.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

DANGER

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the

engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever advanced forward SLOW, lever back toward operator FAST).

3. Engine ON/OFF Switch – ON position permits engine

 

starting, OFF position stops engine operations.

4.

Recoil Starter (pull rope) – Manual-starting method. Pull

 

the starter grip until resistance is felt, then pull briskly and

 

smoothly.

5.

Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop

 

the flow of fuel.

Operating the engine without an air filter, with a damaged air filter,

NOTE or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

8. Spark Plug – Provides spark to the ignition system. Set spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean spark plug once a week.

9. Muffler – Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER

operate the engine with the muffler removed.

10. Fuel Tank – Holds unleaded gasoline. For additional information refer to engine owner's manual.

PAGE 14 — STOW T-30H TRASH PUMP — PARTS MANUAL — REV. #0 (05/30/03)

Image 14
Contents Model T-30H Trash Pump 2 Stow T-30H Trash Pump Parts Manual REV. #0 05/30/03 Heres HOW to GET Help Stow T-30H Table of Contents Parts Ordering Procedures When ordering parts Please supply the following informationStow T-30H Safety Message Alert Symbols Accidental Starting General Safety Rules for Safe OperationRules for Safe Operation Specifications Pump Specifications Engines STOWT-30H General Information ApplicationStow T-30H Pump Components Stow T-30H Basic Engine Initial ServicingStow T-30H PRE-INSPECTION Engine Stow T-30H PRE-SETUP Pump Read safety instructions at the beginning of manualStow T-30H Initial START-UP Engine Stow T-30H Initial START-UP Engine Stow T-30H Trash Pump Parts MANUAL- REV 05/30/03 Stow T-30H Maintenance Pump Pump Vacuum TestStow T-30H Maintenance Pump Stow T-30H Maintenance Engine Engine Maintenance ScheduleStow T-30H Maintenance Engine STOWT-30H Preparation for Long -TERM Storage Pump StorageStow T-30H Trash Pump Parts MANUAL- REV 05/30/03 Troubleshooting Engine STOWT-30H Troubleshooting ENGINE/PUMP STOWT-30H Explanation of Code in Remarks Column Items Found In the Remarks ColumnStow T-30H Suggested Spare Parts Qty DescriptionStow T-30H Pump Assy Pump Assy 32 Stow T-30H Trash Pump Parts Manual REV. #0 05/30/03 Part Name Honda GX240K1PMT2 Engine AIR Cleaner Dual Assy AIR Cleaner Assy Honda GX240K1PMT2 Engine Camshaft Assy Camshaft Assembly Honda GX240K1PMT2 Engine Carburetor Assy Gasket SET Honda GX240K1PMT2 Engine Control Assy ARM, Governor Honda GX240K1PMT2 Engine Crankcase Cover Assy NO. Part no Honda GX240K1PMT2 Engine Crankshaft Assy 13310ZE2651 Honda GX240K1PMT2 Engine Cylinder Barrel Assy SHAFT, Governor ARM Honda GX240K1PMT2 Engine Cylinder Head Assy Part Name QTY. Remarks Honda GX240K1PMT2 Engine FAN Cover Assy CLIP, Tube Honda GX240K1PMT2 Engine Flywheel Assy FAN, Cooling Honda GX240K1PMT2 Engine Fueltank Assy RUBBER, Supporter 107MM Honda GX240K1PMT2 Engine Ignition Coil Assy Coil ASSY., Ignition Honda GX240K1PMT2 Engine Muffler Assy PIPE, Exhaust Honda GX240K1PMT2 Engine Piston Assy Ring SET, Piston 0.75 Optional Honda GX240K1PMT2 Engine Recoil Starter Assy PULLEY, Recoil Starter 64 Stow T-30H Trash Pump Parts Manual REV. #0 05/30/03 Honda GX240K1PMT2 Engine Gasket KIT Assy Honda GX240K1PMT2 Engine Labels Assy Emblem Internal Effective October 1, 2002 Terms and Conditions of Sale Parts Stow T-30H Trash Pump Parts MANUAL- REV 05/30/03 Please have the Model and Serial Number ON-HAND When Calling

T-30H specifications

The Stow T-30H is an advanced stadium and event venue turbine heater that combines efficiency, performance, and cutting-edge technology, making it a preferred choice for a range of applications. Designed specifically to provide optimal heating solutions in large spaces, the T-30H stands out due to its unique features and functionalities.

One of the primary features of the Stow T-30H is its robust heating capacity. With a heating output that can reach up to 30 kW, the unit is capable of efficiently warming areas of significant size. This makes it particularly suitable for indoor sporting events, exhibition halls, and outdoor venues during the colder months. The heater is also engineered to quickly and effectively raise the temperature in a controlled manner, ensuring that users remain comfortable in any setting.

The T-30H incorporates innovative technology designed to maximize its efficiency. It utilizes an advanced combustion system that not only improves fuel consumption but also minimizes emissions. This eco-friendly approach aligns with modern sustainability goals, making the heater an attractive choice for organizations aiming to reduce their carbon footprint.

The ease of operation is another noteworthy characteristic. The Stow T-30H features a user-friendly control panel that allows operators to set and adjust the heating levels conveniently. Additionally, it includes built-in safety mechanisms, such as overheat protection and flame failure detection, ensuring safe operation at all times.

Portability is key in the design of the T-30H. The unit is equipped with durable wheels and a compact profile, allowing for easy transportation and set-up across different locations. This makes it an ideal solution for event organizers who need a heating solution that is both efficient and flexible.

Furthermore, the Stow T-30H is compatible with various fuel sources, offering versatility for users. With options for propane, natural gas, and diesel, it can cater to diverse operational needs and preferences.

In summary, the Stow T-30H delivers powerful heating capabilities combined with modern technology and user-friendly operation. Its focus on efficiency, safety, and portability makes it an excellent choice for stadium and event venue heating needs, ensuring comfort for participants and audiences alike. With this remarkable heater, organizations can enhance the experience of their events, no matter the season.