Stow Stow T-30H PRE-SETUP Pump, Read safety instructions at the beginning of manual

Page 16

STOW T-30H — PRE-SETUP (PUMP)

Before Starting

1.Read safety instructions at the beginning of manual.

2.Place pump as near to water as possible,onafirmflat,levelsurface.

3.Toprimepump,removefillcap(Figure2)andfillpumpcasing with water. If the pump casing is not filled with water before starting, it will not begin pumping.

CAUTION :

Pump casing must be filled with water before using pump. Otherwise pump will not be able to begin pumping.

WARNING :

DO NOT open fill cap if pump is hot!Water inside may be under pressure.

4.Checkforleaksbetweenpumpandengine.Ifwaterisleaking between the pump and engine housing, the seal inside the pump may be worn or damaged. Continued operation of the pumpisnot recommended.Furtherusageofthe pumpunder theseconditionsmaycauseseverewaterdamagetoengine.

Hoses and Clamps

1.Check that all hoses are securely attached to the pump. Make certain suction hose (Figure 2) does not have any air leakage.Tighten hose clamps and couplings as required.

2.Itisrecommendedthat 2 clampsbeusedwhensecuringthe suction hose to the inlet side (suction) of the pump.

3.Remember suction hoses must be rigid enough not to collapse when the pump is in operation.

4.Check that the discharge hose (Figure 2) is not restricted. Place hose so that it lays as straight as it is possible on the ground. Remove any twists or sharp bends from hose which may block the flow of water.

Suction and discharge hoses are

NOTE available from Multiquip. Contact your nearest dealer for more information.

5.The discharge hose is usually a collapsible (thin-walled) hose, however if a thin-walled discharge hose is not avail- able, a rigid suction hose can be substituted in its place.

6.Make sure the suction strainer (Figure 2) is clean and securely attached to the water end of the suction hose. The strainer is designed to protect the pump by preventing large objects from being pulled into the pump.

CAUTION :

The strainer should be positioned so it will remain completely under water. Running the pump with the strainer above water for long periods can damage the pump.

CAUTION :

DO NOT pump flammable fluids, corrosive chemicals or fluids containing toxic substances. These fluids can create potentially dangerous health and environmental hazards. Contact local authorities for assistance.

CAUTION :

This pump uses a water-cooled mechanical seal to prevent water from seeping into the engine. The passage of water through the pump casing lubricates the seal and prevents it from overheating. NEVER! operate the pump without water in the casing as this will cause damage to the mechanical seal.

PAGE 16 — STOW T-30H TRASH PUMP — PARTS MANUAL — REV. #0 (05/30/03)

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Model T-30H Trash Pump 2 Stow T-30H Trash Pump Parts Manual REV. #0 05/30/03 Heres HOW to GET Help Stow T-30H Table of Contents Parts Ordering Procedures When ordering parts Please supply the following informationStow T-30H Safety Message Alert Symbols Accidental Starting General Safety Rules for Safe OperationRules for Safe Operation Specifications Pump Specifications Engines STOWT-30H General Information ApplicationStow T-30H Pump Components Stow T-30H Basic Engine Initial ServicingStow T-30H PRE-INSPECTION Engine Stow T-30H PRE-SETUP Pump Read safety instructions at the beginning of manualStow T-30H Initial START-UP Engine Stow T-30H Initial START-UP Engine Stow T-30H Trash Pump Parts MANUAL- REV 05/30/03 Stow T-30H Maintenance Pump Pump Vacuum TestStow T-30H Maintenance Pump Stow T-30H Maintenance Engine Engine Maintenance ScheduleStow T-30H Maintenance Engine STOWT-30H Preparation for Long -TERM Storage Pump StorageStow T-30H Trash Pump Parts MANUAL- REV 05/30/03 Troubleshooting Engine STOWT-30H Troubleshooting ENGINE/PUMP STOWT-30H Explanation of Code in Remarks Column Items Found In the Remarks ColumnStow T-30H Suggested Spare Parts Qty DescriptionStow T-30H Pump Assy Pump Assy 32 Stow T-30H Trash Pump Parts Manual REV. #0 05/30/03 Part Name Honda GX240K1PMT2 Engine AIR Cleaner Dual Assy AIR Cleaner Assy Honda GX240K1PMT2 Engine Camshaft Assy Camshaft Assembly Honda GX240K1PMT2 Engine Carburetor Assy Gasket SET Honda GX240K1PMT2 Engine Control Assy ARM, Governor Honda GX240K1PMT2 Engine Crankcase Cover Assy NO. Part no Honda GX240K1PMT2 Engine Crankshaft Assy 13310ZE2651 Honda GX240K1PMT2 Engine Cylinder Barrel Assy SHAFT, Governor ARM Honda GX240K1PMT2 Engine Cylinder Head Assy Part Name QTY. Remarks Honda GX240K1PMT2 Engine FAN Cover Assy CLIP, Tube Honda GX240K1PMT2 Engine Flywheel Assy FAN, Cooling Honda GX240K1PMT2 Engine Fueltank Assy RUBBER, Supporter 107MM Honda GX240K1PMT2 Engine Ignition Coil Assy Coil ASSY., Ignition Honda GX240K1PMT2 Engine Muffler Assy PIPE, Exhaust Honda GX240K1PMT2 Engine Piston Assy Ring SET, Piston 0.75 Optional Honda GX240K1PMT2 Engine Recoil Starter Assy PULLEY, Recoil Starter 64 Stow T-30H Trash Pump Parts Manual REV. #0 05/30/03 Honda GX240K1PMT2 Engine Gasket KIT Assy Honda GX240K1PMT2 Engine Labels Assy Emblem Internal Effective October 1, 2002 Terms and Conditions of Sale Parts Stow T-30H Trash Pump Parts MANUAL- REV 05/30/03 Please have the Model and Serial Number ON-HAND When Calling

T-30H specifications

The Stow T-30H is an advanced stadium and event venue turbine heater that combines efficiency, performance, and cutting-edge technology, making it a preferred choice for a range of applications. Designed specifically to provide optimal heating solutions in large spaces, the T-30H stands out due to its unique features and functionalities.

One of the primary features of the Stow T-30H is its robust heating capacity. With a heating output that can reach up to 30 kW, the unit is capable of efficiently warming areas of significant size. This makes it particularly suitable for indoor sporting events, exhibition halls, and outdoor venues during the colder months. The heater is also engineered to quickly and effectively raise the temperature in a controlled manner, ensuring that users remain comfortable in any setting.

The T-30H incorporates innovative technology designed to maximize its efficiency. It utilizes an advanced combustion system that not only improves fuel consumption but also minimizes emissions. This eco-friendly approach aligns with modern sustainability goals, making the heater an attractive choice for organizations aiming to reduce their carbon footprint.

The ease of operation is another noteworthy characteristic. The Stow T-30H features a user-friendly control panel that allows operators to set and adjust the heating levels conveniently. Additionally, it includes built-in safety mechanisms, such as overheat protection and flame failure detection, ensuring safe operation at all times.

Portability is key in the design of the T-30H. The unit is equipped with durable wheels and a compact profile, allowing for easy transportation and set-up across different locations. This makes it an ideal solution for event organizers who need a heating solution that is both efficient and flexible.

Furthermore, the Stow T-30H is compatible with various fuel sources, offering versatility for users. With options for propane, natural gas, and diesel, it can cater to diverse operational needs and preferences.

In summary, the Stow T-30H delivers powerful heating capabilities combined with modern technology and user-friendly operation. Its focus on efficiency, safety, and portability makes it an excellent choice for stadium and event venue heating needs, ensuring comfort for participants and audiences alike. With this remarkable heater, organizations can enhance the experience of their events, no matter the season.
Top Page Image Contents