GE Monogram ZCGP150LII dimensions 33-3/4 min, 35 max, 14-7/8

ZCGP150LII - GE Monogram™ 15" Built-In Compactor for Custom Panels

Dimensions and Installation Information (in inches)

This compactor is designed as a built-in appliance only. It may be located in any convenient space under a countertop.

DO NOT OPERATE FREE-STANDING because the compactor will tip over when the drawer is pulled out.

Front View (not to scale)

Additional Specifications: A 115 Volt, 60 Hz. power supply is required. An individual properly grounded branch circuit protected by a 15- or 20-amp circuit breaker or time delay fuse is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical outlet location is critical for proper cord storage when compactor is installed.

If the compactor is to be located in or near a corner of base cabinets, allow 6” minimum clearance from the corner for bag removal on the right side.

15-1/8"	34" - 35"
min.

24" min.

Locate the outlet 18" min. from the floor, 3" min. from either side.

3/4
Thick
Custom
Panel	29-5/16
		33-3/4" min.
		to
		35" max.

23"

14-7/8 14-7/8"

For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000.

Clearances: Allow 6" clearance to a vertical wall on the right side for bag removal. Allow 23" at the front for a full drawer opening.

Listed by

Underwriters

Laboratories

R

Specification Revised 10/05 160008