Fisher & Paykel OR120 installation instructions Fitting the anti-tilt bracket

Installation instructions

Fitting the anti-tilt bracket	Dotted line showing the position
	of the cooker when installed

9

Important!

To restrain the appliance and prevent it tipping accidentally, the anti-

tilt bracket and restraining plate supplied must be fitted according to the instructions below.

1 Drill four 8mm diameter holes for the fixing screws (two in the wall and two in the floor-see Fig.5) and insert the plastic plugs supplied.

Important!

Before drilling the holes, check that you will not damage any pipes or electrical wires.

Anti-tilt bracket

Rear central foot of cooker

Fig. 5 Attaching the anti-tilt bracket and sliding the cooker into place

2Attach the anti-tilt bracket to the floor and rear wall using the four screws supplied, as shown in Fig. 5.

3After attaching the anti-tilt bracket securely, slide the cooker into place. Ensure that the rear central foot slides under the bracket, as shown in Fig.5.

4Access the bracket by removing the left drawer (Fig. 6):

a Slide out the left drawer completely.

b Press the lever of the left guide rail down and pull the lever of the right guide rail up.

cHolding the levers, disengage and remove the drawer.

5Fix the restraining plate by sliding it into place and securing it with the fixing screw and washer supplied. See Fig. 7.

6Replace the left drawer (Fig. 8):

a Insert the drawer rails into the guide rails.

b Gently push the drawer in completely; the safety catches will automatically hook.

Important!

Beware of sharp edges when removing or replacing the drawer.

Fig. 6 Accessing the anti-tilt bracket by removing the left drawer

Screw & Washer

Restraining plate

Fig. 7 Fixing the restraining plate

Fig. 8 Replacing the left drawer