Fisher & Paykel OR120 installation instructions Cooktop troubleshooting, Problem

Page 27

Cooktop troubleshooting

Problem

Possible solutions

25

A burner does not light.

Check that the power to the cooker is switched on at the wall.

Check the gas supply valve is turned on and the supply to the house is working. You should hear the gas when you turn a burner on.

Check the gas bottle is not empty.

The ignitors may be dirty. Clean them with a toothbrush and methylated spirits.

The burner parts may not be located properly. Check the assembly and make sure the burner cap is sitting flat.

My burner flames are yellow or hard to start.

The burner parts may not be located properly. Check the assembly and make sure the burner cap is sitting flat.

If you use bottled gas, this may indicate you are getting near the end of the bottle.

Check the burner parts are clean and dry.

The gas pressure may not be at the correct level. Check with your service person or installer.

Your cooker may not be set up for the gas you are using. Check this with your service person or installer.

One of my burners has an uneven

Check the burner parts are clean and dry. Check the

flame.

assembly and make sure the burner cap is sitting flat.

 

 

The flame goes out at low

The gas supply pressure may be low. Check this with

settings.

your service person or installer.

 

The low setting may have been adjusted incorrectly.

 

Check this with your service person or installer.

 

If you use bottled gas, this may indicate you are

 

getting near the end of the bottle.

My burners do not turn down much (when running on bottled gas or LPG).

Your cooktop may not have been adjusted correctly. Check this with your service person or installer.

The flame tips are very yellow.

Call your service person to service the cooker.

 

 

There are objectionable odours.

Call your service person to service the cooker.

The flame appears to lift off the burner.

Call your service person to service the cooker.

There is an electricity failure.

If there is an electricity failure, you can still use your cooktop. Light the burners by holding a match close to the side of the burner and turning the control

knob to the (High) position. Wait until the flame is burning evenly before adjusting.

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Installation instructions Page Contents Electrical Safety and warningsInstallation GeneralCooker must be earthed Operation Important safety precautions Installation instructions Product dimensionsFixing the backguard Rear and Side Clearances Cooker overall dimensions mmClearances Overhead ClearancesScrew/unscrew the feet to get the required height Levelling the cookerFitting the anti-tilt bracket Correctly lifting the cooker Moving the cookerLocating the area for gas and electrical connection Locating the area for gas and electrical connectionLPG Connecting the cooker to the gas supplyLeak-testing and flame-testing the cooker Installation with a flexible hose assemblyConverting to a different gas type Dual burner Replacing the injectorsSemi-rapid Triple ring wok burnerOutside crowns of dual burner Adjusting the minimum burner settingSemi-rapid and triple-ring wok burners Inside crown of dual burnerLubrication of the gas valves Table for the choice of injectorsPower supply Connecting the power supply cableInstructions Wiring diagramIntroducing your cooker Right oven controlsLeft oven controls Gas burners Using your gas cooktopUsing the dual gas burners Before using your cooktopUsing the gas burners semi-rapid and triple-ring wok Flame failure safety featureUsing the cast-iron griddle If a burner does not lightIf the flame is irregular Using the wok stand Matching cookware to burnerDiameters of pans which may be used on the cooktop Problem Cooktop troubleshootingClock display Function Temperature Control buttons Using your ovens for the first timeOven controls Illuminated symbolsButtons To set the clockBake Cooking functionsFAN Bake Using the electronic timer To set the oven for automatic cooking Automatic cookingLeft drawer Using your warmer drawerTo use the moisture selector Reversible rackCleaning the gas cooktop Care and cleaningGeneral advice Cleaning the outside of the cookerReplacing the burners Cleaning the burner parts and trivetsCorrect positioning of cap and ring triple-ring wok burner Replacing the triple-ring wok burnerReplacing the dual burners Cleaning the cast-iron griddleDrop-down grill element Cleaning the inside of your ovensCaring for the catalytic panels Cleaning the enamel cavityCleaning the fat filter When you replace the panels, make sure thatSliding shelf supports To remove the sliding shelf supportsTo re-fit the sliding shelf support onto the side racks Removing the inner and middle panes of glass Cleaning the oven door glassCare and cleaning Replacing the middle and inner panes of glass Care and cleaning Removing the oven doors Replacing the drawers Removing the drawersRemoving the oven lamp Replacing the oven lampBefore you call for service or assistance Warranty and servicePage Page NZ AU
Related manuals
Manual 48 pages 8.14 Kb Manual 52 pages 7.67 Kb Manual 48 pages 15.45 Kb

OR120 specifications

Fisher & Paykel OR120 is a versatile and high-performance range cooker designed to meet the culinary needs of both home chefs and professionals. Boasting a combination of innovative technologies and thoughtful design, the OR120 delivers exceptional cooking flexibility and efficiency, allowing users to create a variety of dishes seamlessly.

One of the standout features of the OR120 is its dual fuel configuration. This system combines the responsive heat of gas burners with the even and controlled cooking of an electric oven. This dual fuel setup offers enhanced cooking precision, ensuring that users can achieve the best results for diverse cooking techniques, from rapid boiling to slow roasting.

The OR120 features a spacious oven compartment with a generous capacity, making it ideal for preparing large meals or multiple dishes simultaneously. Equipped with multiple cooking functions, including bake, broil, and convection, the oven ensures even heat distribution for consistent cooking results. The convection feature is particularly useful, as it circulates hot air around the oven, reducing cooking times and enhancing flavor development.

For ease of usability, the OR120 comes equipped with intuitive controls and a large digital display. This user-friendly interface allows for precise temperature adjustments and cooking time settings, providing users complete control over their culinary creations. Additionally, the integrated timers and cooking progress indicators enhance the cooking experience, providing convenience and assurance.

Aesthetic appeal is another hallmark of the OR120. Its sleek design, available in a range of finishes, such as stainless steel and classic white, ensures that it complements any kitchen décor. The high-quality materials used in its construction not only enhance its durability but also make it easy to clean.

Safety is a priority in the OR120 design, with features such as flame failure protection and a cooling fan to prevent overheating. This ensures peace of mind while cooking, allowing users to focus on the task at hand.

In summary, Fisher & Paykel’s OR120 stands out as a premium choice for those seeking a combination of performance, versatility, and style in a range cooker. With features designed to enhance cooking efficiency and ease of use, it’s a valuable asset for any kitchen. Whether for everyday meals or special occasions, the OR120 can elevate the cooking experience, allowing users to explore their culinary passions with confidence.
Top Page Image Contents