Amana PGB58B Rollout Protection Shown Without Heat Shield, Position of Limit Control Gas Valve

WARNING

To avoid the risk of fire or explosion, a qualified servicer must investigate the problem which caused the roll-out pro- tection device to open before manually resetting the device.

Flame Roll-Out

Protector

(Manual Reset)

Reset After Lock-out

Should ignition not be achieved after three tries for any reason, it will be necessary to reset the electronic igni- tion module. To reset, it is only necessary to turn the thermostat below room temperature for thirty seconds, and then reset it to the desired temperature. The fur- nace may also be reset after lockout by disengaging the electric disconnect switch to the furnace for thirty sec- onds.

Operating Instructions (Heating)

NOTE: Figure 16 illustrates the proper gas valve mount- ing location.

Flame Roll-Out

Protector

(Manual Reset)

Figure 14

Rollout Protection

(Shown Without Heat Shield)

Secondary Limit Control

On the PGC and PGB series, a second limit control is placed on the blower scroll that will open if the blower should fail, causing elevated temperatures at the con- trol. The reason for elevated temperatures at the control should be ascertained and repaired prior to resetting this manual reset control. The secondary limit control is lo- cated behind the front center panel on the blower scroll. (Figure 15).

Secondary Limit

Control

NOTE: Position of Limit Control

Differs From Model to Model.

Figure 15

Position of Limit Control

Figure 16

Gas Valve

1.Close the manual gas valve external to the furnace.

2.Turn off the electrical power supply to the furnace.

3.Set the room thermostat to its lowest possible set- ting.

4.Remove the right hand door on the front of the fur- nace by removing screws.

5.This furnace is equipped with an ignition device which automatically lights the burner. Do NOT try to light burner by any other method.

6.Turn the gas control valve knob to the OFF position. Do not force. (Figure 16).

7.Wait five minutes to clear out any gas.

8.Smell for gas, including near the ground. This is im- portant because some types of gas are heavier than air. If you have waited five minutes and you do smell gas, immediately follow the instructions on Page 6 of this manual. If you have waited five minutes and you do NOT smell gas, turn the gas control valve knob to the ON position. (Figure 16).

9.Replace the door on the front of the furnace.

10.Open the manual gas valve external to the furnace.

11.Turn on the electrical power supply to the furnace.

12.Set the thermostat to desired setting.

NOTE: There is a one minute delay between thermo- stat energizing and burner firing.

19