Reassemble the external part of the Pannarello.
•We recommend cleaning the water tank daily. For an easier removal of the water tank, move the steam wand / Pannarello upwards:
-Remove the small white fi lter in the water tank and wash it under running drinking water.
-Reposition the small white fi lter in its housing by gently pressing and turning it at the same time.
-Fill the water tank with fresh drinking water.
•Empty and clean the drip tray daily. Perform this operation also when the fl oat is raised.
•Also clean the seat of the tray every week through the openings on the bottom of the machine.
Brew Group
•The brew group should be cleaned every time the coffee bean hopper is fi lled or at least once a week.
•Turn off the machine by pressing the ON/OFF button and remove the plug from the socket.
•Remove the coffee grounds drawer. Open the service door.
•To remove the brew group, pull it by the handle and press the «PUSH» button. The brew group must be washed only with lukewarm water with no deter- gent/soap.
•Wash the brew group with lukewarm water and carefully clean the upper fi lter.
•Thoroughly wash and dry all the parts of the brew group.
•Thoroughly clean the inside of the machine.
•Make sure that the two reference signs match up.
•Make sure that the lever is in contact with the brew group. Press the “PUSH” button to make sure that the brew group is in the correct position.
Lubricate the brew group after approximately 500 brewing cycles. The grease to lubrica- te the brew group may be purchased
at authorised service centres.
•Lubricate the brew group guides using the supplied grease only.
•Apply the grease evenly on both side guides.
•Insert the brew group in its seat until it locks into place WITHOUT pressing the “PUSH”button.
•Insert the coffee grounds drawer. Close the service door.
• 36 •