Gaggia 037RG Rinse/Self-cleaning Cycle, Press the button to brew a long cof- fee, To the position

Steady on

Steady on

Using the machine for the first time or after a long period of inactivity.

These simple operations will make it pos- sible to always brew excellent coffee.

1Place a large container under the dispensing spout.

2Before starting the procedure, check that the following icons are displayed.

3Select the pre-ground coffee function by pressing the ““ button one or more times.

Do not add the pre-ground coffee to the compartment.

The icon will appear on the display.

4Press the button to brew a long cof- fee.

5Wait until brewing is completed and empty the water tank.

6Repeat the operations from step 1 to step 5 for 3 times; then continue with step 7.

7Place a container under the steam wand (Pannarello, if supplied).

8Turn the selector switch clockwise to set it to the “ ”position.

	The following icon will be displayed.
Steady on
9	Dispense water until the no water si-
	gnal is displayed, then turn the selec-	English
	tor switch counter-clockwise to set it
Steady on	to the “ ”position.
10	At the end, fill the water tank again.
	Then the products can be brewed as
	described in the following sections.

Rinse/Self-cleaning Cycle

This cycle allow rinsing the coffee circuits with fresh water.

The cycle is carried out:

•At machine start (with cold boiler)

•After priming the water circuit (with cold boiler)

•During the Stand-by preparation phase (if a coffee product has been brewed)

•During the phase of activating the stand-by mode after pressing the “STAND-BY”button (if a coffee product has been brewed).

	A small amount of water will be dispen-
	sed to rinse and heat all the machine
	components; during this phase the icons
Cyclic blinking	blink in sequence.

Wait for the cycle to fi nish automatically.

You can stop dispensing by pressing either coffee button and/or the “Stand-by” button.

• 29 •