2.With the variable speed control in the “o” position, the machine is switched off. in the “i” posi- tion, the machine operates continuously at low speed. in the “ii” position, the machine operates continuously at high speed. in the “p” (pulse) position, the machine operates at high speed until the variable speed control is released.
Cleaning
1.always clean the machine thoroughly immediately after use.
2.First switch off the machine by setting the variable speed control to the “o” position.
Unplug food processor before cleaning.
3.if you have used the dicing grid, leave it in the machine and force out any remaining cubes with a brush before removing the grid.
4.take all removable parts off of the machine base and remove the sealing ring from the groove on the inside of the lid, clean in a hot detergent solution, rinse, and dry them thoroughly and then replace the sealing ring in the groove.
5.all cutting tools can be washed in a hot detergent solution.
6.Wipe the machine base with a damp cloth.
7.Never use sharp objects, scouring powder or pads or high pressure hoses.
8.Never leave the knife or cutting tools in a wet condition or on a stainless steel bench when they are not being used, but dry them thoroughly and always place them on the wall rack (if avail- able).
TroUBleshooTing
Machine Overheats:
1.To eliminate the risk of damage to the motor, the unit is fitted with thermal motor protection that automatically switches off the machine if the temperature of the motor should become too high.
2.the thermal motor protection has automatic reset, which means that the machine can be started again when the motor has cooled down, which usually takes between 10 and 30 minutes.
The Machine Will Not Start or Stops While Running and Can Not Be
1.check that the power plug is properly inserted in the wall socket.
– 11 –