Items Provided with the Unit

FITTING THE D3252XLFI, D3532XLFI AND D3532XLFIWS

CUSTOM DOOR PANEL

The D3252XLFI, D3532XLFI, and D3532XLFIWS can only be installed with a fully-integrated custom door panel that extends from the toe kick to the counter top. The unit comes with everything needed to make installing the door panel easy. The door is predrilled for the panel’s mounting screws.

♦Two 3/8” screws

♦Four 1-3/4” screws

CUSTOM PANEL DIMENSIONS

Width:	23-1/2” (597 mm)
Height:	30 1/8" (765 mm)
	(Measured from the top of the panel to the lower edge of
	the kitchen cabinet.)
Thickness:	3/4” (19 mm) max
Weight:	Up to 22 lb.

Fit the handle onto the panel according to the manufacturer’s instructions. (NOTE: A handle should be used rather than a knob, because a knob does not provide enough grip.)

NOTE: Before fitting the custom panel, the dishwasher must be installed underneath the cabinet. After you’ve made the required measurements, pull the machine out again to install the panel.

NOTE: Specifications subject to change without notice.

	"	mm
	1/8
		765
	30

PREPARING THE WOOD PANEL FOR MOUNTING

1.Lay the template edge-to-edge with the lower edge of the dishwasher

door or the adjusting frame. The broken line on the template must pass through the center of the keyholes on the door.

2. Using a pen or screw, punch holes in the template where the keyholes are.

3. Lay the template on the back of the wood panel, edge-to-edge with the rear of the lower edge and the left edge of the panel.

4. Mark the location of the hole on the panel.

5. Turn the template over and lay it on the right side of the wood panel and mark the location of the second hole.

6. Screw the short screws into the markings on the wood panel, letting them project by about 1/16".

Page 10