ADJUSTING THE LEVELING LEGS
Now that all the connections are made and the machine is in place under the cabinet, you should make the final height adjustment.
1.You should set the rear foot first. To do
this, use a screwdriver to rotate the adjusting screw on the bottom front of the machine. Turn the screw clockwise to raise the foot and counterclockwise to lower it.
2.Using a 1/2” (12 mm) wrench, adjust the locking nuts until the machine is
level. (The machine may have an inclination of 1/4"
maximum without affecting its performance.)
3.When the feet are properly adjusted, tighten the locking nuts to the base pan.
FASTENING THE DISHWASHER TO THE CABINET
It’s necessary to fasten the dishwasher to the cabinet so it won’t tilt when the door is opened or if something heavy is placed on the door. Use only screws provided with the machine.
1.Use option A for U.S. or European standard installations. Use option B only for European standard installations.
2.Cover the screw heads with the plastic plugs provided with the machine.
3. When the machine is properly | Mounting |
attached, check that the feet are | Screws |
tight against the floor and that the |
|
machine is level. |
|
BB
AA
NOTE: When it is not possible to attach the dishwasher to the cabinet, you should install tip guards. (See “Tip Guards” on page 2.)
INSTALLING THE TOE KICK
SETTING THE TOE KICK
DEPTH
1.Press the grey catches toward each other to release the bracket.
2.Pull out the holders as far as required.
3.Press in the catches so that they lock the brackets in place.
4.Hang the toe kick onto the holders by inserting it into the grooves.
Once you have the toe kick bracket in place, you can install the toe kick, as follows:
1.Lay the insulation on the back side of the toe kick to make sure it fits properly.
2.Peel the adhesive protection strip off the insulation and press it firmly to the back side of the toe kick, making sure you don’t cover any slots on the toe kick.
3.Positioning the notches on the toe kick at the edge of the access panel, slide the toe kick up behind the access panel then let it slide to the floor.
4.Adjust the toe kick depth.
Page 9