INSTALLATION
WARNINGS
READ ALL OF THE INSTRUCTIONS IN THIS MANUAL BEFORE YOU ATTEMPT TO INSTALL THE EQUIPMENT AND CAREFULLY FOLLOW THEM.
ALWAYS DISCONNECT THE UNIT FROM THE POWER SOURCE BEFORE PERFORMING ANY SERVICE OR MAINTENANCE.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED SERVICE AGENCY APPROVED & AUTHORIZED BY AMERICAN PANEL CORPORATION. DOING OTHERWISE MAY VOID THE WARRANTY.
Note: Any changes made to the equipment without authorization from the factory will void the warranty.
PREPARATION
9Check the integrity of the unit once it is unpacked.
9Check that the available power supply corresponds to the ratings on the unit's nameplates and that correctly rated electrical protection is provided.
9Quick disconnect must be provided for this unit by the installer.
9If additional refrigerant should be needed, be certain to use the correct type.
9Make certain that adequate drainage is provided.
Ambient air temperature should be no greater than 90oF to ensure the rated performance.
INSTALLATION
THIS MODEL HAS REMOTE CONDENSING UNIT. The condensing unit and the cabinet must be connected and installed in accordance with the following instructions:
LOCATION
Ambient air temperature for air cooled condensing units should be no greater than 90oF to ensure the rated performance. A remote condensing unit must be located away from direct sunlight if installed outdoors, or, if it is indoors, a water cooled condensing unit should be used.
DIMENSIONS
Overall dimensions are
ELECTRICAL AND REFRIGERATION SPECIFICATIONS
MODEL | VOLTAGE |
| CABINET | REMOTE CONSENSER |
AMPS | POWER SUPPLY | BTU/H AT 14°F EVAP. TEMP. | ||
|
| CORD | & 105°F COND. TEMP. | |
|
|
| ||
208/1/60 | 8 | 25,000 |
NOTES:
1.The condensing unit and the cabinet must be connected to separate electrical power supplies.
2.Each wire must be connected to its corresponding terminal.
3.The ground wire must be connected to an efficient ground terminal.
7