Alpine PXA-H701 owner manual Mixing bass sound to the rear channel

4 Turn the Rotary encoder to select “Auto”, then press the ENTER button. Test tone output is repeated for each of the different speaker channels. They will be repeated in the order shown below.

If no operation is performed for 2 seconds, the channel switches to the next channel.

L (Left front) C (Center) R (Right front)

LS (Left surround) RS (Right surround)

5 While the test tones are being produced from the speakers, turn the Rotary encoder to adjust so that the volume of the different speakers is equal.

•The adjustment range for the different speakers is ± 10 dB.

•Adjust based on the front speakers.

6 Press the SETUP button repeatedly to quit the setup mode.

Adjusting the level for individual speakers (manual)

1)At step 4 above, select “Manual”, then press the ENTER button.

2)Press the CHANNEL button or ENTER button to select the speaker you wish to adjust.

3)Turn the Rotary encoder to adjust the output level.

4)Repeat steps 2) and 3) above to adjust the levels of the different speakers.

5)Press the SETUP button again to quit the setup mode.

NOTES

•If a speaker is set to the off mode, that speaker’s level adjustment cannot be made.

Refer to “Speaker setup” (page 22).

•Once the settings are made, we recommend storing them in the memory. See page 28 for instructions.

Mixing bass sound to the rear channel

This function mixes the front channel audio signals to the audio signals output from the rear speakers, improving the sound in the vehicle’s rear seat.

NOTE

Avoid stopping, pausing, switching the disc, cueing, fast-forwarding or switching the audio channel of the player while making this adjustment. The setting is canceled if the decode mode is switched.

1 Press the SETUP button. The setup mode is set.

2 Turn the Rotary encoder to select the “5.1CH SETUP” mode, then press the ENTER buton.

3 Turn the Rotary encoder to select “REAR MIX”, then press the ENTER button.

4 Turn the Rotary encoder to select “REAR MIX ON” or “REAR MIX OFF”, then press the ENTER button.

When set to “ON”, the front audio signals are mixed into the audio signals output from the rear speakers.

5 Turn the Rotary encoder to adjust the level, then press the ENTER button.

The level can adjusted in five steps: –6, –3, 0, +3 and +6. The higher the level, the more bass is output from the rear speakers. (The effect differs according to the software (DVD, etc.).)

6 Once the settings are completed, press the SETUP button repeatedly to quit the setup mode.

NOTES

•This adjustment is ineffective when the rear speaker setup setting is set to “OFF”.

•For linear PCM signals, the voice is output from the rear speaker regardless of the REAR FILL and REAR MIX setting.

•Once the settings are made, we recommend storing them in the memory. See page 28 for instructions.

23-EN