6 Press and hold the CHANNEL button for at least 2 seconds and select “L and R (LR)” or “L or R”.
L and R (LR) 
L or R
(factory default)
L and R (LR): Sets the same adjustment values for the left and right channels.
L or R: Different adjustment values can be set for the left and right channels.
7 Press the CHANNEL button and select the desired channel, then press the ENTER button.
When “L and R (LR)” is selected:
*1
Front 1 
Front 2 Rear Center
Sub. W
When “L or R” is selected:
Front 1 L | Front 1 R | Front 2 | L | Front 2 R |
*3 | *2 |
|
|
|
Sub. W | Center | Rear R |
| Rear L |
*1 When center is set to subwoofer, it is not displayed.
*2 When center is set to subwoofer, it becomes Sub.W(L).
*3 When center is set to subwoofer, it becomes Sub.W(R).
8 Turn the Rotary encoder to adjust the time correction value (0.00 ~ 20.00ms), then press the ENTER button.
T C R / P H A S E L F 1 R R
D E L A Y C: | R C |
| |
P H A | 1 0 . | 2 5 m s | |
S E : | 1 8 0 | ° | |
*The difference in the sound when the defeat mode is turned off (adjusted time
correction) and on (default value) can be checked as follows:
1)While in the adjustment mode, press and hold the TCR/PHASE button for at least 2 seconds.
2)Press the TCR/PHASE button to switch the defeat mode on and off and listen to the difference in the sound.
3)To quit, select the desired setting, then press the ENTER button.
Note that if you press the ENTER button with the defeat mode turned on, the adjustments are reset to the defeat on status (the default values).
9 Turn the Rotary encoder to switch the phase, then press the CHANNEL button.
Press the ENTER button to return to step 8.
0 
180
T C R / P H A S E L F 1 R R
D E L A Y C: | R C |
|
1 0 . 2 5 m s | ||
P H A S E : | 1 8 0 | ° |
10 Repeat steps 7 to 9 to adjust other channels.
11 Once the adjustments are completed, press the TCR/PHASE button.
NOTES
•When the speaker is set to the “OFF” mode, the TCR for that speaker is ineffective. Refer to “Setting the speakers” (page 4).
•After making the settings, we recommend storing them in the memory. For instructions, see page 28.