Comprehensive Guide to Using the Alpine PXA-H701 Manual

Using Dolby Surround

CHANNEL

ENTER

SETUP

Rotary encoder

OFF:

When no speaker is connected

SMALL:

When a speaker that cannot play low frequencies (80 Hz or less) is connected

LARGE:

When a speaker that can play low frequencies (80 Hz or less) is connected

*1: It is not possible to set the front speakers to “OFF”.

*2: If the front speakers are set to “SMALL”, the rear and center speakers cannot be set to “LARGE”.

6 Press the SETUP button repeatedly to quit the setup mode.

Speaker setup

The PXA-H701 can be set according to the playable frequency range of your speakers. Check the playable frequency range of the speakers (not including the subwoofer) before performing this operation to verify whether the speakers can play low frequencies (of about 80 Hz or less).

NOTE

Avoid stopping, pausing, switching the disc, cueing, fast-forwarding or switching the audio channel of the player while making this adjustment. The setting is canceled if the decode mode is switched.

1 Press the SETUP button. The setup mode is set.

2 Turn the Rotary encoder to select the “5.1CH SETUP” mode, then press the ENTER button.

3 Turn the Rotary encoder to select the “SPEAKER SETUP”, then press the ENTER button.

4 Press the CHANNEL button to select the speaker, then press the ENTER button.

Front

Center

Rear

Sub. W

NOTES

•If the center speaker is turned "OFF", the center channel's audio signals are added to the audio signals output from the front speakers.

•If you set the speaker response to “OFF”, also set the speaker setting to “OFF”. (See page 4.)

•Perform the setup for all the speakers (“Front”,

“Center”,“Rear” and “Sub. W”). If not, the sound may not be balanced.

•When center is set to subwoofer, the setting is ineffective even if center is set with this function.

•Once the settings are made, we recommend storing them in the memory. See page 28 for instructions.

•Through changing the settings on each speaker, a change in the output of the other speakers may occur due to the setting requirements.

•When using the PRO LOGIC II, if the rear speaker is set to "LARGE", then there will be no output from the sub-woofer.

Adjusting the speaker levels

Use the PXA-H701’s test tones to make the volume adjustments of the different speakers. When levels are equal, a strong sense of presence can be heard from the different speakers at the listening position.

NOTE

Avoid stopping, pausing, switching the disc, cueing, fast-forwarding or switching the audio channel of the player while making this adjustment. The setting is canceled if the decode mode is switched.

5 Turn the Rotary encoder to select the speaker property, then press the ENTER button. Repeat steps 4 and 5 to set the various items.

*1*2

OFF SMALL LARGE

(Subwoofer is only ON/OFF.)