Nespresso BEC800 manual Menu Modes, Empt Ying Mode, Coffee & Steam Pipe, Turn steam handle to on

MENU MODES

1. To enter menu modes, press and hold the Espresso button	2. Set the dials to the required settings (see	3. Once selected, press the Lungo button to confirm (middle light steady to
while turning the machine on (middle light steady orange).	chart below).	confirm, and blinks orange accordingly to selected number).

	Set Espresso dial to:	Set Lungo dial to:
1:	Auto Shut Off	1: 9 min, 2: 30 min, 3: 60 min, 4: 2 hrs, 5: 8 hrs
2:	Water Hardness	1: hard, 2: medium, 3: soft
3:	Emptying	See emptying section
4:	Descaling	See descaling section
5:	Reset To Factory Setting	Simply press the Lungo button to reset to factory setting (power save: 9 min, water hardness level: hard).

EMPT YING MODE EN

Note: your machine should be emptied before and after a long period of non-use.

COFFEE & STEAM PIPE

1. While in menu mode, set Espresso button to position 3	2. Remove water tank and lift lever.	3. Press Lungo button to empty machine (ready when
for emptying.		coffee lights stop blinking).

4. Turn steam handle to ON. 5. Adjust steam pipe into steam out position. 6. Set steam handle to :

Middle light blinking: emptying

Middle light steady: done

7.Machine switches off automatically when finished.

NOTE: when in menu mode you can change between options without exiting each time. To exit menu mode, press and hold the Espresso button for 5 seconds (steady coffee lights confirm exit).

	18
NOTE: appliance will be blocked for approximately 20 minutes after emptying.
	19

5927_MAESTRIA_MASTER_2012_v12.indd 20-21

07.02.13 14:55