Programming the Mill (Continued)
NOTE: After unit is turned off or automatically shuts off after one hour, mill coarseness setting will default to level 4 or medium grind. Coarseness setting will also default to level 4 in the event of power interruption.
Programming the Timer to
Make Coffee Later
You can program the timer to automatically mill and brew coffee up to 24 hours in advance.
1.Press and hold the TIME button for 2 seconds. The green TIME light will come on and display will read 12:00. The unit is now in the timer programming mode.
2.Press “HR” and “MIN” buttons to program start time. Small dot in upper left corner signifies clock is programmed for A.M. No dot in upper left corner means clock is programmed for P.M.
3.The timer display and LED light will flash 5 times to indicate that timer is now set. Press and release the TIME button. The green TIME light will come on.
NOTE: If unit is operated before programmed time, timer will need to be reset. To do this, simply depress TIME button. LED light will come on to indicate timer has been reset.
IMPORTANT: If programming timer to future start time, make sure water tank has been filled and mill/brew basket contains the correct amount of beans.
Care and Cleaning
CAUTION: ALWAYS UNPLUG UNIT BEFORE CLEANING AND ALLOW TO COOL FOR 15 MINUTES BEFORE ATTEMPTING TO CLEAN. NEVER USE SCOURING AGENTS. NEVER IMMERSE MACHINE IN LIQUIDS. NEVER CLEAN MACHINE UNDER RUNNING WATER.
Decalcification of Your Mill & Brew Coffeemaker
For best tasting coffee, and to promote longer use of your Mill & Brew, follow the procedure for decalcification every month, or after 30 uses. If you have hard water, you may notice a slowing of the brewing process— an indication that you should decalcify more frequently.
7