Brewing Instructions (Continued)
coffee in mill/brew basket per every two cups of coffee desired. Replace lid. Make sure basket is firmly seated in assembly, lid on basket is secured and lid to assembly is closed before attempting to operate unit.
NOTE: You may substitute ground coffee for coffee beans by turning off the mill. To do so, push the Mill button. The light will come on. Place ground coffee into mill/brew basket. Use approximately 1 tablespoon of grounds per cup of coffee.
4.You are now ready to initiate the automatic mill and brew process. (If you wish to use the delay timer so you can program the coffeemaker to mill and brew later, please read section entitled “Programming the Timer” to make coffee later.
Programming the Mill
CAUTION: DO NOT OPEN UNTIL BLADES STOP AND BREWING IS COMPLETE. CLEAN AND DRY ALL PARTS AFTER EACH USE.
If you desire a medium grind, your machine is automatically preset to “4” or medium grind; refer to step 2 below. If you wish to program a finer or coarser grind, start with step 1.
1.To set the mill to grind your beans to the desired level of coarseness, press SELECT button to select different coarseness levels,
2.Press ON button to initiate the mill/brew process; the red ON light will come on. Mill will start. After mill stops, unit will automatically switch to brewing operation. To interrupt milling or brewing, press OFF button. Red ON light will then turn off. Do not attempt to lift mill/brew lid until operation has come to a complete stop.
3.After brewing is complete, remove decanter from warming plate and serve. Coffeemaker warming plate will cycle on and off to maintain proper coffee temperature for one hour before it automatically shuts off and the red ON light turns off.
4.Unplug and allow unit to cool for 10 minutes between cycles. Allow to cool completely before attempting to clean.
6