Char-Broil 7101366 manual Qty

3

•Attach rotary ignitor to control panel using two #8x1/2" self-tap screws (A).

•Attach round end of ignitor wire to rotary ignitor (A).

•Attach valve to control panel holding valve in correct position using two #6-32x3/8" threaded screws (A).

•Make sure valve is inside burner tube. Secure control panel using one #10x3/8” self-tap screw through single tab side (B).

•Slide heat shield between fryer body and louver side of control panel. Secure with two #10x3/8" self-tap screws assuring heat shield is attached using bottom screw (C).

•Attach spade end of wire to electrode (D).

A#8x1/2"

Self-Tap Screw	#6-32x3/8"
	Threaded Screw

	Control Panel	Qty: 3		Qty: 2
	Louver Side		Qty: 2
		#10x3/8"		#6-32x3/8"
			#8x1/2"
	Ignitor	Self-Tap Screw		Threaded Screw
Valve angles		Self-Tap Screw
		B
to side	Valve, Hose,
Hose angles		View is shown
downward	Regulator Assembly
		with fryer upside-down	Valve and Burner
				Centered
	Ignitor Wire
		Burner Tube
C		#10x3/8"	Valve end
		Self-Tap Screw
View is shown	Heat Shield slides	Carefully insert valve end into
with fryer upside-down	between Control Panel	burner tube making sure valve
	and body and underneath	is centered with burner tube,
		After aligned correctly, secure
Ignitor	Wire.
		with one self-tap screw on single
wire		tab of control panel.

ld ie sh e Heat plac in

Heat shield hole

aligned with

Bottom screw

#10x3/8" Self-Tap Screws

Spade end

of ignitor wire

D

Electrode	View is shown
	with fryer upside-down

07101378 • 13