Char-Broil 10101480 manual Control Panel Slots

3

Assemble the control panel to the appliance:

•Install 1 each #10x3/8” self-tap screw into the bottom hole of the Heat Shield shown below (A). Install a second #10x3/8" self-tap screw into the top hole of the appliance body shown below (A). Do not completely install the screws at this time. Be sure two threads are engaged into the appliance body. (A1)

•Slide the control panel slots under the screws heads while holding the heat shield in position between appliance body and louver side of control panel. Secure with 1 each #10x3/8" self-tap screw as shown below (B).

•With control panel installed, review ( C) to ensure correct assembly.

•Attach spade end of wire to electrode (D).

A

View is shown	#10x3/8"
with unit upside-down	Self-Tap Screws

Bottom hole of heat shield B

A1

#10x3/8"
Self-Tap Screws
loosely installed.	#10x3/8"
	Self-Tap Screw

C

View is shown

with unit upside-down

Valve and Burner

Centered

Ignitor wire

Qty: 3

#10x3/8" Self-Tap Screw

Heat Shield slides

between Control Panel

and body and underneath Wire.

shield Heat place in

Control Panel

Slots

Burner Tube

Valve end

Make sure valve

is centered with burner tube

D

Spade end

of ignitor wire

Electrode

14