Hold coupling nut and regulator as shown for proper connection to LP cylinder valve.
6.Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the
NOTE:
If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the
connection, do not use this regulator!
Leak Testing Valves, Hose and Regulator
1.Turn control knob to OFF.
2.Be sure regulator is tightly connected to LP cylinder.
3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding.
4.Brush soapy solution onto areas circled below.
DANGER
• | Do not insert any tool or foreign object into the valve |
| outlet or safety relief valve. You may damage the valve |
| and cause a leak. Leaking propane may result in |
| explosion, fire, severe personal injury, or death. |
| WARNING |
• | This appliance is not intended to be installed in or on a |
| boat. |
• | This appliance is not intended to be installed in or on an |
| RV. |
• | Never attempt to attach this appliance to the self- |
| contained LP gas system of a camper trailer or motor |
| home. |
• Do not use this appliance until | |
• | If a leak is detected at any time, STOP and call the fire |
| department. |
• | If you cannot stop a gas leak, immediately close LP |
| cylinder valve and call LP gas supplier or your fire |
| department! |
5.If “growing” bubbles appear, there is a leak. Close LP cylinder valve immediately and retighten connections. If leaks cannot be stopped do not try to repair. Call for replacement parts. Order new parts by giving the serial, model number and name and part number of items needed (see parts list) to the Grill Service Center at the number listed on front cover.
6.Always close LP cylinder valve after performing leak test by turning hand wheel clockwise.
7