Aegis Micro C 8 16 41-4i Positioning, Your appliance needs air, Housing Dimensions

Positioning

This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rat- ing plate, which is located on the inside left of the appliance.

The following table shows which ambient temperature is correct for each climate classification.

Climate classification	for an ambient temperature of
SN	+10 to +32 °C
N	+16 to +32 °C

The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem- peratures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.

For building-in and door reversal instructions please refer to the relevant instructions on the following pages.

Your appliance needs air

For safety reasons, minimum ventila- tion must be as shown Fig.

Attention: keep ventilation openings clear of obstruction;

50 mm	min.
	200 cm2
	min.
	200 cm2
D567

Housing Dimensions

Height	1580 mm
Depth	550 mm
Width	560 mm

20