Kuhn Rikon 5100 instruction manual Transporting Safety Precautions

Page 7

5100TK OPR 6270US R060106

SAFETY

TRANSPORTING SAFETY PRECAUTIONS

WHEN TRANSPORTING A LOADED MIXER, FOLLOW THESE SAFETY PRECAUTIONS. FAIL- URE TO DO SO COULD RESULT IN A LOSS OF CONTROL AND SEVERE INJURY OR DEATH.

Do not allow anyone to ride on or in the mixer.

Reduce speed when traveling loaded and/or over rough, soft, or wet terrain. Exercise caution on side slopes and when turning corners.

When working on slopes or inclines, travel uphill or downhill. Keep the truck transmission in gear when going downhill.

Avoid driving on loose fill, rocks, inclines, ditches, and holes.

Always park the mixer on level ground and block the truck’s tires.

If mixer is for highway transit the end user is responsible for federal, state and local vehicle safety regulation compliance (example: under-ride requirements, lighting and weight limitations).

When transporting the mixer, always keep the power discharge chute or slide tray in the upright (retracted) position. For long transport distances the power chute must be locked in place using the chains provided.

LOCK CHUTE

AS SHOWN

7

Back to Table of Contents

Image 7
Contents Vertical Maxx Mixer Table of Contents Lubrication for 5144, 5156 Lubrication for 5173, 5185 Introduction Using this ManualModel and Serial Number Information Read the OPERATOR’S Manual SafetyUnderstand Safety Words and Symbols Follow Safety Instructions and PrecautionsOperating Safety Precautions Transporting Safety Precautions Unit Safety DecalsSafety RED Reflector Models 5144, 5156, 5168, 5173, 5185 Safety Decal PlacementSafety Lubrication Mixer SetupSafety Shields PTO Driveline Setup and AdjustmentLimitations SafetyMixer Operation GeneralStep #1 Processing Materials Operation Using Mechanical DriveMixer Setup AdjustmentsLoading Sequence Step #2 Mixing MaterialsStep #3 Unloading Step #4 Other Mixing Recommendations Operation Using Hydrostatic DriveStep #1 Processing Materials Step #2 Mixing Materials Step #3 Unloading Moving Knives in or OUT Knife AdjustmentRemoving Knives Adding KnivesHAY Stop Adjustment Mixer Operation Optional Equipment Inspection & Adjustments Inspection and AdjustmentsLubrication for 5144, 5156 MaintenanceLubrication for 5173, 5185 Planetary Gearbox OIL Change MaintenanceMiscellaneous Specifications 5144, 5156 Specifications 5173, 5185