Safety Precautions
Read all instructions completely before attempting to operate this unit.
*** SAVE THESE SAFETY INSTRUCTIONS ***
To reduce the risk of electrical shock, fire, or personal injury follow the guidelines below:
•Before connecting unit to a power source, be sure the voltage supplied is the same as that specified on the name plate of the unit.
•Check outlet to ensure proper grounding of the electrical cable. Have a licensed electrician check the A/C power outlet if you are not sure.
•Use this unit for its intended purpose as described by literature.
•Make sure power cord is located so that it will not be stepped on, tripped over, or otherwise subjected to stress of heat, oil, or sharp edges. Do not close doors on the cord.
•To reduce the risk of damage to the electric plug and cord, disconnect by plug rather than by the cord.
•Do not use this unit if cord or plug is in poor condition. If it has been exposed to weather or immersed in water, have a qualified serviceman inspect and replace parts as necessary.
•WARNING! NEVER HANDLE PLUG, CORD, OR UNIT WITH WET HANDS OR WHILE STANDING IN WATER.
•Use special care when moving heavily loaded units.
•Do not store combustible material on or around the unit.
•Do not operate this unit empty.
•When using the unit at a distance where an extension cord becomes necessary, a
Operation
Load oven with desired amount of electrodes. To turn on the unit, simply plug the power cord into appropriate single phase A/C source and adjust thermostat to desired setting. (Check name plate for voltage.)
The ovens are supplies with a 6’ UL listed type S.J. cord. However, due to the many different recepticle configurations in the field a plug is not supplied. When attaching plug to power cord, be sure the plug is an approved component and is rated for the proper voltage and amperage.
All units meet electrical code requirements when used with a grounding plug and a grounded receptical.