Pre Installation, Unpacking | IFB Appliances ELENA EX manual

INSTALLATION

Pre Installation

1.It is mandatory to have a 16 amp. 3-pin 230V AC, 50Hz electrical point with a 16 amp. MCB or Automatic short circuit protection device within 1 meter of the machine. Make sure it has proper earthing.

2. Fixed plumbing is recommended
for the machine.	The water inlet
of the machine has a collar
with3/4”parallel	internal	threads.
The water supply point with an
external 3/4”	parallel	thread
should be available within1 meter
of the machine’s location.

WATER		MACHINE
SUPPLY	REDUCER	WATER
		INLET
STOP
LOCK
1/2	3/4

3. Two options on the water inlet and

drain pipe connection are shown.

In case these possibilities do not

exist for the drain pipe, please

arrange an additional length of

pipe.

DRAIN

PIPE

WATER INLET

DRAIN

PIPE

4.Please inform our service centre for installation and demonstration of the machine once the points mentioned above have been completed.

Unpacking

1. Remove Carton.

2. Remove top packing cover.

3. Remove side packing and plastic jacket.

4. Remove packing from the bottom of the

motor

5.Place the machine at the site at which it is to be Installed, and put the rat mesh.