You cannot find your device on the list:
If your device is not listed in the List view, make sure the device is turned on and that it is located within the same segment as your computer.
3. Click the Configuration button.
Or
4.In the Network Interface Card Properties window that appears, select the tab for the protocol that you want to configure.
Configure the network interface settings to suit your operational environment. Refer to the following sections for information on each protocol setting.
Location | See 6.3 | Printer Menu |
Administrator Name, Return to Default | See 6.4 | Print Server Menu |
TCP/IP | See 6.5 TCP/IP Menu | |
Wireless Network | See 6.6 | Wireless Menu |
5.When you are done with all the settings, click OK.
6.In the window that appears, click OK again.
7.The Password window appears. Initially, no password is set.
z If you do not want to set your password yet, just click OK here without entering anything. Your settings will be sent to the network interface.
z If you do want to set your password, refer to 5. Setting the Password.
Note:
Do not turn off the device or send other data to it until you see the message “Configuration successfully completed” as TMNet WinConfig is still communicating with the device.
8.It takes a maximum of three minutes for all the settings to become effective.
Do not turn off the device until that happens. After about three minutes have passed, choose Refresh from the View menu and confirm the current settings.
This completes the configuration of the network interface.
Note:
You are advised to store the settings you have made in a safe place.
5/25
©SEIKO EPSON CORPORATION