RUNNING AN EFFECTS PROCESSOR THRU YOUR SRM 6302 / 8302
1.Connect speakers, microphones and other equipment to the SRM 6302 / 8302 as before.
2. Next, connect a cord from the Effects Out/Footswitch jack to the input of the effects processing unit. Return the signal to the SRM 6302 / 8302 by connecting a cord from the output of the effects unit to the Effects In jack on the SRM. (When PA 2 is assigned to the main front of house enclosures, be sure one enclosure is connected to a PA 1 Out jack and the other is connected to a PA 2 Out jack.)
3.The Effects control in each channel strip adjusts the amount of signal sent to the reverb / effects bus where all the effects signals from the channels are summed. The Effects control in the master section adjusts the signal level to the effects processing unit and the reverb pan.
4.Be sure to turn on the tape deck, keyboard or other instruments and outboard gear before powering up the SRM 6302 / 8302.
11