Fender SRM 8302, SRM 6302 manual

Page 12
Manual background

SRM WITH AN EXTERNAL MONITOR POWER AMP FOR MONITOR SPEAKERS

1.Connect a cord from the Mon Out jack to the monitor power amp and system. With an external monitor power amp, the SRM’s second power amp may be assigned to the main bus for additional power to the front of house speakers. When PA 2 is assigned to the main front of house enclosures, be sure one enclosure is connected to the PA 1 Out jacks and the other is connected to the PA 2 Out jacks.

2.The Monitor control in the master section adjusts the signal level to the monitor power amp.

3.Be sure to turn the tape deck, keyboard or other instruments and gear on first, then the SRM 6302 / 8302.

12

Image 12
Contents POWERED MIXERS From Fender Pro AudioBill Schultz Fender Musical InstrumentsINTRODUCTION PROFESSIONAL POWERED MIXERAssignable Dual Power Amplifiers +48V DC Phantom PowerINPUT CHANNEL CONNECTIONS MASTER CONTROL PANEL FUNCTIONS Phantom Power supply is offBefore plugging or unplugging anyTAPE INPUT / OUTPUT JACKS REAR PANELtape/effects return to main and 100-UP INPUT / OUTPUT CONNECTIONS BASIC SETUP OF YOUR SRM 6302 /TROUBLESHOOTING GROUNDING AND HUMSTOLEX COVERING CARE SIMPLE SRM SETUP WITH MONITORS RUNNING AN EFFECTS PROCESSOR THRU YOUR SRM Page 1.Connect a cord from the Main Out jack to an external power amp. Be sure one monitor enclosure is connected to a PA 1 Out jack and the other is connected to a PA 2 Out jack. PA 1 power amp can now be assigned to monitor speakers by connecting a small, shielded jumper cable from the Mon Out jack to PA 1 In. Next, connect the PA2 power amp to Monitor Out by placing the PA2 Assign switch to the Mon position. The Monitor control will now adjust volume for both PA 1 and PA SRM 6302 / 8302 SIGNAL FLOW DIAGRAM Typical signal pathfor each channel SPECIFICATIONS FOR THE SRM SPECIFICATIONS FOR THE SRM DESIGNATION TYPE