INPUT / OUTPUT CONNECTIONS |
| BASIC SETUP OF YOUR SRM 6302 / 8302 |
|
|
|
The SRM 6302 / 8302 has a variety of connectors on its input / output panels. Below is a chart listing the various types and their pin outs.
Jack | Style | Connection | Pin Out |
MIC | XLR | Balanced | Pin 1 = GND |
INPUTS | Female | Input | Pin 2 = POS |
|
|
| Pin 3 = NEG |
LINE | 1/4" | Balanced | Tip = POS Signal |
INPUTS | TRS | Input | Ring = NEG Signal |
|
|
| Sleeve = GND |
|
|
|
|
MAIN, | 1/4" TS | Unbalanced | Tip = Signal Output |
MONITOR, |
| Output | Sleeve = GND |
EFFECTS |
|
|
|
OUTPUTS |
|
|
|
FOOT | 1/4" TS | Switch | Tip = Signal |
SWITCH |
|
| Sleeve = GND |
|
|
|
|
PA 1, | 1/4" TS | Unbalanced | Tip = Input Signal |
PA 2, |
| Input | Sleeve = GND |
EFFECTS |
|
|
|
INPUTS |
|
|
|
TAPE | Dual | Unbalanced | Inner Ring = Signal |
IN / OUT | RCA | Input / | Outer Shell = GND |
|
| Output |
|
PA 1, | 1/4" TS | Speaker | Tip = Signal |
PA 2 |
| Output | Sleeve = GND |
OUT |
|
|
|
|
|
|
|
Before using the SRM 6302 / 8302, please read and follow the steps listed below:
1.IMPORTANT Heed all safety warnings when operating the SRM 6302 / 8302.
2.Make sure the power switch is in the OFF position and all volume levels are in the 0 position.
3.Next, plug the supply cord into a power source with the correct voltage.
5.Connect the speaker cables from the SRM 6302 / 8302 PA out jacks to the input jacks of the speaker cabinets.
6.Connect the cord(s) from any outboard gear, microphones or other signal source(s) to the appropriate input jack(s) on your SRM 6302 / 8302's.
7.First, turn all outboard gear, instruments and other equipment ON, then the SRM 6302 / 8302.
8.Increase volume controls and effects level controls to their desired levels, listening for feedback or ringing.
9.When shutting down the SRM 6302 / 8302, turn OFF the SRM 6302 / 8302 first then any additional outboard gear, instruments or other equipment.
For more detail on setting up your SRM 6302 / 8302, please refer to the diagrams on pages 10 thru 13.
8