Cleaning & Maintenance, Cleaning External Parts

section 5 Cleaning & Maintenance

Cleaning External Parts

IMPORTANT: Make sure the Brewer is unplugged before cleaning.

Regular cleaning of the Brewer’s external components is recommended.

1.Never immerse the Brewer in water or other liquids. The Brewer housing and other external components should be cleaned with a damp, non-abrasive, lint-free cloth.

2.The Drip Tray and Drip Tray Plate should be periodically inspected and cleaned with a damp, non-abrasive, lint-free cloth. The Drip Tray and Drip Tray Plate should not be put into the dishwasher. To remove the Drip Tray,

simply slide it toward you. Remember, when the red Drip Tray Overfill Indicator appears, the Drip Tray is almost full. Carefully remove the Drip Tray and discard its contents.

The Drip Tray has a snug fit to ensure it stays put in transit.

Cleaning the K-Cup®Portion Pack

Holder Assembly

1.Cleaning the Parts — The K-Cup Holder Assembly can be placed onto the top shelf of a dishwasher. NOTE: Use low temperature cycles in the dishwasher. To remove the K-Cup Holder Assembly from the Brewer, lift the Brewer Handle to open. Grasp the top of the K-Cup Holder with one hand. With the other hand, push up on the bottom of the K-Cup Holder until it releases (fig. 1). After cleaning, align the K-Cup Holder with the opening using the two front ribs as a guide, and snap into place from the top (fig. 2).

fig. 1

fig. 2