Keurig K40, K45 owner manual De-Scaling Instructions, Service, Storage, Disable Auto Off feature

Page 12

SECTION 3 Cleaning & Maintenance

De-Scaling Instructions

A. PREPARE

Step 1:To begin, you will need the following:

At least 48 oz. of undiluted white vinegar

Access to an empty sink

A large ceramic mug (do not use a paper cup)

Step 2:Empty the water from the Water Reservoir. NOTE: If you are using a water filter inside the Water Reservoir, remove it before proceeding.

Step 3:Disable Auto Off feature.

B. FILL AND CLEAN

Step 1: Pour approximately 48 oz. of the vinegar into the Water Reservoir. Fill to and not beyond the MAX FILL line.

Step 2:Place a large mug on the Drip Tray Plate and run a cleansing brew. DO NOT USE A K-CUP®PACK, just press a Brew Button. Pour the contents of the large mug into the sink.

Step 3:Repeat the brew process without a K-Cup®pack until the blue Add Water Light illuminates.

Step 4:Now let the brewer stand for at least 4 hours while still on.

Step 5:Discard any residual vinegar and rinse the Water Reservoir thoroughly.

C. RINSE

Step 1:Ensure the Water Reservoir is filled with fresh water. Fill to and not beyond the MAX FILL line.

Step 2:Place a large mug on the Drip Tray Plate and run a cleansing brew. Pour the contents of the large mug into the sink.

Step 3:Repeat brew process until the blue Add Water Light is illuminated.

Step 4:You may need to perform additional cleansing brews if you notice any residual taste.

NOTE: If the red Descale Light is still illuminated after completing the procedure, repeat the de-scaling procedure above.

Service

Beyond these recommended cleaning and maintenance procedures, this brewer is not user serviceable. For service, please refer to the Warranty section of this guide.

Storage

Empty the Water Reservoir before storing and take care to ensure that you store your brewer in a safe and frost free environment. Please be sure to store your brewer in its upright position to avoid water leakage from the inner tank. If you store the brewer in a cold environment, you run the risk of water freezing inside the brewer and causing damage. When you prepare to use it after storage, we recommend rinsing the Water Reservoir with fresh water and running three cleansing brews without a K-Cup®pack.

If you plan to move your brewer to a different location, turn the brewer off, unplug it and empty the Water Reservoir. If your brewer has been in

an environment below freezing, please be sure to let it warm to room temperature for at least 2 hours before using.

12

Image 12
Contents Keurig K-CupK40/K45 Elite Brewer Important Safeguards Safe Operation & Use Table of Contents Helpful Hints Unpacking InstructionsPlease see page 7 for brewing instructions Please see pages 11 and 12 for instructionsFeatures K40/K45 Elite Brewer Power Light Green Auto Off ButtonWater Reservoir Lid Setting Up Your Brewer Set-Up & First BrewIndicate the brewer is powered on Ready to Brew Your First CupLower the Handle completely to close the Lid 25 oz. serving and the Large Mug will yield aStopping the Brew Process Adding WaterBrewing Iced Beverages Brewing Hot WaterPurging the Brewer Controls & Indicators LED Control Center Cleaning & MaintenanceProgramming Auto Off Timer Feature Cleaning External PartsDe-Scaling Your Brewer Service Disable Auto Off featureDe-Scaling Instructions StorageTroubleshooting Light and SmallMug Button Under faucet refer toLimited One Year Warranty Keurig, IncorporatedScan. Click. Call Have questions? We’re here to helpLearn more and reach us quickly without leaving home Keurig, Incorporated All rights reserved