Set-Up & First Brew, Setting Up Your Brewer

SECTION 1 Set-Up & First Brew

IMPORTANT: You cannot use your Keurig® brewer until it has been set-up for its first use as set forth below.

NOTE: If brewer has been exposed to temperatures below freezing, allow brewer at least two hours to reach room temperature before brewing. A frozen or extremely cold brewer will not operate.

fig. 1 Setting Up Your Brewer

1. Unwrap cord and plug the brewer into a grounded outlet. Remove all pieces of packing tape.

2. Place a large mug (10 oz. minimum) on the Drip Tray Plate.

3. Remove the Water Reservoir from brewer by first removing Lid from Reservoir (fig. 1), then lifting Reservoir straight up and away from brewer (may be tight). Rinse with fresh water.

4.Fill Water Reservoir with bottled or filtered water so that the water is to and not beyond the MAX FILL line.

Lock Tabs

fig. 2

fig. 3

5.Place Water Reservoir base into the left side of the brewer and be sure the Water Reservoir Lock Tabs engage with the brewer (fig. 2). Replace Lid on Water Reservoir.

6.Press Power Button found on upper right panel of the brewer. The green Power Light will illuminate. NOTE: A K-Cup®pack should not be used for this sequence.

NOTE: If the Water Reservoir is empty or

not in place on the brewer, the blue Add Water Light will illuminate. The Small Mug Button will not be activated until water is added to the Water Reservoir.

7.The brewer will automatically fill with water and then the water will be heated. This will take about 4 minutes. During the heating period, the red Heating Light will illuminate. Once the water is heated, the red Heating Light will turn off and the Small Cup, Small Mug and Large Mug Buttons will illuminate. NOTE: Do not lift Handle during this heating period.

Small Mug